ESPA study guide 2022 with complete solution

ESPA study guide 2022 with complete solution When pulling several cables through a wire pathway, wrapping the cables tightly together with zip-ties may do which of the following? Crush cables and damage interior wire An RJ-45 modular jack has how many conductors 8 Which of the following is used to terminate UTP cable on to 110-style blocks? punch down tool In which of the following situations should a laminated beam be drilled through? A laminated beam should never be drilled through. Which of the following sets standards for electrical installations in order to ensure proper safety? National Fire Protection Agency (NFPA What document includes a designation for a cable run and its source, destination, and purpose? Wire chart/ Cable schedule Which of the following should be used when pulling multiple cables through conduit Appropriate cable lubricant Which of the following would be used to test for a dial tone at the telco demarc? Telephone butt set Which of the following should be followed when data or signal cables MUST be located near AC power lines Signal data cables should cross AC power cables at 90 degrees What is the MINIMUM recommended working bend radius for Cat-5e cable? 4 times the diameter of the cable How high, in inches, is one EIA rack space unit or "1 RU"? 1.75 Which of the following needs to be completed in order to properly complete wiring installation in a rack? Sufficient strain relief of all cabling and service loops to make replacement, repair, or adjustment accessible Which of the following is CORRECT concerning a 12 AWG wire? Greater current carrying capacity than a 14 AWG wire What is the MAXIMUM pulling tension for maintaining verification of category 5 UTP wire? 25 lbs What is the hazard in using staples to install an RG-6 coaxial cable? Pinching of the dielectric will change the impedance of the cable and interfere with proper performance Which of the following should be done to the unused outlets in an RF signal distribution system? Terminate with a 75 ohm terminator