CIP Level 1 NACE-CIP1-001 Practice Test Questions and Answers Graded A+

CIP Level 1 NACE-CIP1-001 Practice Test Questions and Answers Graded A+ How to Become a Coating Inspector To become a coating inspector, complete the Coating Inspector Program (CIP) offered by NACE International. There are two levels of certification. The CIP level 1 certification is for inspectors who perform basic, non-destructive inspections. Obtain this certification by completing the required NACE exams. CIP level 2 certification requires two years of experience in the field, as well as completion of the NACE exams. CIP Level 1 NACE-CIP1-001 - Coatings Inspector Program Level 1 CIP Level 1 covers the technical and practical fundamentals of coating inspection work. Students will be prepared to perform basic coating inspections using non-destructive techniques and instrumentation. Passcert provides students valid CIP Level 1 NACE-CIP1-001 dumps with knowledge and application of coating materials, along with techniques for surface preparation. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of action is to: A. Break the blisters to see what's inside B. Document the problem and advise the Contractor and Owner's representative C. Document the problem and advise the Contractor D. Extract any liquid that may be inside the blister and send it to the lab for further analysis Answer: B .Dew point is the temperature at which A. water freezes. B. humidity decreases C. condensation occurs. D. the air is saturated. Answer: C If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a A. dry film thickness (DEI) measurement. B. wet film thickness (WFT) measurement. C. blotter test for the presence of oil and water. D. vial lest. Answer: C Upon arrival of coating materials, the inspector should A. review coating contractors' plans for storage of coating materials and confirm they meet national, local and owners' fire and environmental regulations. B. observe and document the amount of material and batch numbers. C. observe aryl document that the applicator WFT at regular intervals during application. D. observe and document time frame and environmental conditions between each coat. Answer: B Relative humidity is A. a measure of the amount of moisture in the air compared to saturation level. B. a measure of the amount of moisture in the air compared to the air temperature. C. the lowest temperature at which moisture forms on a steel surface. D. the highest temperature at which moisture forms on a steel surface. Answer: A Galvanic corrosion occurs on which of the following substrates: A. Concrete B. Fiberglass Reinforced Plastic C. Metal D. Wood Answer: C When applying Thermal Spray Coatings the specification is most likely to refence: A. SSPC PA 2 B. NACE SP 0178 C. NACE SP 0188 D. SSPC-CS 23.00/AWS C2.23/NACE No. 12 Answer: D What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge? A. 1 cm (.39 inch) B. 2.5 cm (1 inch) C. 6.35 cm (2.5 inch) D. 2.5 millimeters (.10 inch) Answer: B Download Valid NACE_CIP1-001 questions