UniversityPhysicsVolume2-Ch10
University Physics Volume II Unit 2: Electricity and Magnetism Chapter 10: Direct-Current Circuits Conceptual Questions 1. What effect will the internal resistance of a rechargeable battery have on the energy being used to recharge the battery? Solution Some of the energy being used to recharge the battery will be dissipated as heat by the internal resistance. 2. A battery with an internal resistance of r and an emf of 10.00 V is connected to a load resistor R r . As the battery ages, the internal resistance triples. How much is the current through the load resistor reduced? Solution The current is cut in half. 3. Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery. Solution P I 2R e r + R æçè ö÷ø 2 Re2R(r + R)- 2 , dP dR e2 éëê(r + R)- 2 - 2R(r + R)- 3ùûú 0, (r + R) - 2R (r + R)3 éêêë ùúúû 0, r R 4. A voltage occurs across an open switch. What is the power dissipated by the open switch? Solution No power is dissipated by the switch because zero current flows through the circuit when the switch is open. 5. The severity of a shock depends on the magnitude of the current through your body. Would you prefer to be in series or in parallel with a resistance, such as the heating element of a toaster, if you were shocked by it? Explain. Solution It would probably be better to be in series because the current will be less than if it were in parallel. 6. Suppose you are doing a physics lab that asks you to put a resistor into a circuit, but all the resistors supplied have a larger resistance than the requested value. How would you connect the available resistances to attempt to get the smaller value asked for? Solution connect two or more in parallel 7. Some light bulbs have three power settings (not including zero), obtained from multiple filaments that are individually switched and wired in parallel. What is the minimum number of filaments needed for three power settings? Solution two filaments, a low resistance and a high resistance, connected in parallel 8. Can all of the currents going into the junction shown below be positive? Explain. Page 1 of 25
Document information
- Uploaded on
- September 4, 2022
- Number of pages
- 25
- Written in
- 2022/2023
- Type
- Other
- Person
- Unknown