API 1104 TERMS & DEFINITIONS VERIFIED STUDY GUIDE
Automatic Welding - Answers - Arc welding with equipment that performs the entire
welding operation without manual manipulation of the arc or electrode other than
guiding or tracking and without a manual welding skill requirement of the operator.
Back Weld Repair - Answers - Repair weld made at the back side of a groove weld.
Branch Weld - Answers - Completed groove and/or fillet weld joining a set-on or set-
in branch pipe or a set-on or set-in branch fitting to a run pipe.
Company - Answers - Owner company or the engineering agency in charge of
construction.
Note: A _________ may act through an inspector or another authorized
representative.
Contractor - Answers - That which includes the primary contractor and any
subcontractors engaged in work covered by this standard.
Cover Pass Repair - Answers - Repair to the weld face located and contained within
the external reinforcement, including external undercut.
Defect - Answers - Imperfection of sufficient magnitude to warrant rejection based on
the acceptance criteria in this standard.
Double Repair - Answers - Second repair in a previously repaired area of a
completed weld; typically referred to as a "repair of a repair" or a "re-repair"
Full Thickness Repair - Answers - Repair weld originating from the weld face that
penetrates completely through the weld thickness.
Grinding - Answers - Mechanical means to remove weld metal using abrasive
methods.
Imperfection - Answers - Discontinuity or irregularity that is detectable by methods
outlined in this standard
Indication - Answers - Evidence obtained by nondestructive testing
Internal Concavity (IC) - Answers - Bead that is properly fused to and completely
penetrates the pipe wall thickness along both sides of the bevel but whose center is
somewhat below the inside surface of the pipe wall.
Mechanized Welding - Answers - Process where parameters and torch guidance are
controlled mechanically or electronically but may be manually varied during welding
to maintain the specified welding conditions.
Automatic Welding - Answers - Arc welding with equipment that performs the entire
welding operation without manual manipulation of the arc or electrode other than
guiding or tracking and without a manual welding skill requirement of the operator.
Back Weld Repair - Answers - Repair weld made at the back side of a groove weld.
Branch Weld - Answers - Completed groove and/or fillet weld joining a set-on or set-
in branch pipe or a set-on or set-in branch fitting to a run pipe.
Company - Answers - Owner company or the engineering agency in charge of
construction.
Note: A _________ may act through an inspector or another authorized
representative.
Contractor - Answers - That which includes the primary contractor and any
subcontractors engaged in work covered by this standard.
Cover Pass Repair - Answers - Repair to the weld face located and contained within
the external reinforcement, including external undercut.
Defect - Answers - Imperfection of sufficient magnitude to warrant rejection based on
the acceptance criteria in this standard.
Double Repair - Answers - Second repair in a previously repaired area of a
completed weld; typically referred to as a "repair of a repair" or a "re-repair"
Full Thickness Repair - Answers - Repair weld originating from the weld face that
penetrates completely through the weld thickness.
Grinding - Answers - Mechanical means to remove weld metal using abrasive
methods.
Imperfection - Answers - Discontinuity or irregularity that is detectable by methods
outlined in this standard
Indication - Answers - Evidence obtained by nondestructive testing
Internal Concavity (IC) - Answers - Bead that is properly fused to and completely
penetrates the pipe wall thickness along both sides of the bevel but whose center is
somewhat below the inside surface of the pipe wall.
Mechanized Welding - Answers - Process where parameters and torch guidance are
controlled mechanically or electronically but may be manually varied during welding
to maintain the specified welding conditions.