chapter 9 quiz illustrated guide for
student exam question and correct
answers
No derating is allowed when there are only Fastened-in place
one two or three appliances
Type____cable can be foremd in a SE
gooseneck and taped with a self sealing
weather resistant thermoplastic.
The ampere rating of any circuit 100
breaker rated at amperes or less and
1000 volts
or less must be molded stamped etched or
similarly marked into the handle or
escutcheon area.
Conductor sizes are expressed in American Circular mils
Wire Gage (AWG) or in ____
Panel boards shall be mounted in cabinets Dead front
clout boxes or identified enclosures and
shall be _____
The_____including the strip heat and blower Total volt- ampere load
motor is necessary information for
calculating loads.
The ___ for each floor shall be computed Floor area
using the outside dimensions.
The smaller of two or more__loads can be Noncoineicident
omitted as long as they are never
energized simultaneously.
Main bonding jumpers and system Copper
bonding jumpers must be made of
___________________________or other
corrosion-resistant material.
A clothes dryer neutral load on a feeder 70
can be calculated at ___%
Type USE cable used for service laterals Emerge above ground at outside terminations
can ____
Wire ways are___with hinged or removable Troughs (sheet metal or nonmetallic)
covers used to house and protect electric
wires and cables.
, The term appliance designates ___- and Utilization equipment commonly built in standardized types
installed as a unit to perform specific and sizes
functions
student exam question and correct
answers
No derating is allowed when there are only Fastened-in place
one two or three appliances
Type____cable can be foremd in a SE
gooseneck and taped with a self sealing
weather resistant thermoplastic.
The ampere rating of any circuit 100
breaker rated at amperes or less and
1000 volts
or less must be molded stamped etched or
similarly marked into the handle or
escutcheon area.
Conductor sizes are expressed in American Circular mils
Wire Gage (AWG) or in ____
Panel boards shall be mounted in cabinets Dead front
clout boxes or identified enclosures and
shall be _____
The_____including the strip heat and blower Total volt- ampere load
motor is necessary information for
calculating loads.
The ___ for each floor shall be computed Floor area
using the outside dimensions.
The smaller of two or more__loads can be Noncoineicident
omitted as long as they are never
energized simultaneously.
Main bonding jumpers and system Copper
bonding jumpers must be made of
___________________________or other
corrosion-resistant material.
A clothes dryer neutral load on a feeder 70
can be calculated at ___%
Type USE cable used for service laterals Emerge above ground at outside terminations
can ____
Wire ways are___with hinged or removable Troughs (sheet metal or nonmetallic)
covers used to house and protect electric
wires and cables.
, The term appliance designates ___- and Utilization equipment commonly built in standardized types
installed as a unit to perform specific and sizes
functions
