• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 4 out of 31 pages
Exam (elaborations)

Ardms Spi Study Guide Questions And Answers Already Passed Latest Update 100 Correct Answers

Document preview thumbnail
Preview 4 out of 31 pages

ARDMS SPI Exam Study Guide and Reference Material | Expert-Verified Solutions In soft tissue, if the frequency of a wave is increased the Propagation Speed (PS) will... - answer - Remain the Same because stiffness and density affect Propagation Speed. What is the audible range? - answer - 20-20,000Hz 20,000Hz=Ultrasound Frequency is measured in - answer - Hertz (Hz) is Cycles per Second Not affected by sonographer Increase Frequency; Decrease Depth A period is the length of time it takes for - answer - one complete wavelength to pass a fixed point PRP is determined by - answer - Transmit time and receive time. Period is measured in - answer - Time (μs) When the sonographer changes the imaging depth what parameters are changed? - answer - PRP, PRF, Duty Factor What is duty factor? - answer - The percentage or fraction of time that the system is transmitting a pulse (Time Sound is ON or ON-Time). Propagation Speed in SOFT TISSUE - answer - 1.54 mm/μs (1540 m/sec) Unit of measurement for Pulse Duration, Duty Factor, PRP, and Period - answer - Time, (μs) Pulse duration is determined by - answer - Sound Source Only Pulse Duration is controlled by - answer - the ultrasound system and transducer Pulse Duration Formula - answer - pulse duration (μs) = # cycles in pulse/frequency(MHz) PD= Number of cycles in Pulse/ Frequency(Hz) Spatial Pulse Length (SPL) (measurement) - answer - The distance that a pulse occupies in space from the start to the end of a pulse. (mm) Typical values for spatial pulse length in soft tissue. - answer - 0.1 to 1.0 mm Spatial pulse length is determined by - answer - sound source and medium Spatial Pulse Length is directly proportional to - answer - the Number of Cycles in the Pulse and the Wavelength (Directly Proportional means that increased SPL will increase both the number of cycles in the pulse and the wavelength if increased). Spatial pulse length is inversely proportional to - answer - Frequency (MHz) (Inversely Proportional means that increased SPL will lower frequency. This is because axial resolution is better with lower frequency) Pulse Duration (PD) - answer - The actual time from the start of a pulse to the end of that pulse; a single transmit, talking, or "on" time. Time the pulse is on typically measured in (ms). Pulse Length - answer - The distance of the pulse start to end or the duration or length of a single pulse Pulse Length is typically measured in (mm). the ability of an object to resist compression and relates to the hardness of a medium? - answer - Stiffness. Think: ↑ Stiffness ↑ Speed ↓ Density ↑ Speed An increase in pulse repetition frequency would lead to: - answer - Increasing pulse repetition frequency, increases duty factor. ↑ PRF ↑ Duty Factor Which of the following would have the highest propagation speed? - answer - Bone has the highest propagation speed, at m/s. What has the lowest propagation speed? - answer - air technically has the lowest propagation speed at 300 m/s Which has the Slowest Propagation Speed? Water Soft Tissue Bone Lung tissue - answer - Lung Tissue As imaging depth increases, the pulse repetition frequency (PRF) must: - answer - Decrease As imaging depth increase, pulse repeition freqency (PRF) decreases. ↑ Imaging Depth ↓ PRF What describes the amount of refraction that occurs at an interface? - answer - Snell's law Refraction: the redirection of the transmitted sound beam Snell's law describes the angle of transmission at an interface based on the angle of incidence and the propagation speeds of the two media. Pressure is typically expressed in: - answer - Pascals (Pa) The typical range of frequency for diagnostic ultrasound imaging is - answer - 1-20 Mhz is the typical range of frequency for diagnostic ultrasound imaging. The attentuation coefficient in soft tissue is equal to: - answer - Attentuat


Document information

Uploaded on
October 15, 2026
Number of pages
31
Written in
2026/2027
Type
Exam (elaborations)
Contains
Questions & answers
$15.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
SARAHnkalu
4.6
(7)
Sold
41
Followers
0
Items
3917
Last sold
4 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions

Whoops! We can’t load your doc right now. Try again or contact support.