ICC Vapor Recovery VT Exam | Practice Questions & Answers
Type of sealant you should you use on a Phil-Tite Ball Pipe dope
Float nipple:
Number of open valves on the clean air separator: One
You must be CERTIFIED by Healy to re-connect a Healy False
breakaway, True or False?
The type of pressure gauge is recommended to test Healy SYSA gauge measuring 0-100 WC
Vac
On new construction, after July 1, 2004, Can you install an YES-When Piping is monitored and with VAC
in-ground Spill Bucket?
According to Executive Order 201 - Healy P/V Valve 20-50 ft-lbs
should be torqued at
For a fire to burn, these (3) three primary elements must Fuel, Oxygen, Ignition Source
exist:
When working with Electrical - Lock Out Tag Out CAL-OSHA
procedures are under these guidelines.
Organization that certifies vapor recovery systems. CARB or ARB
According to RP 500, a level II technician may NOT Replace VP 1000 Healy Pump
inspect this part.
where hanging hardware repairs must be tracked. GDF maintenance log
approved sealant when assembling a Phil-Tite Drop Tube. JB-Kwik
Material direct bury OPW container sleeve shall be made Stainless steel
of.
What P/V vent cap shall be tightened to. 20-50 ft lbs
From dispenser to manifold - 2" diameter vapor piping ( 2" Vapor piping
ID) and From manifold to tank - 3" diameter vapor piping
(3" ID)
Grade A+ | Updated
, ICC Vapor Recovery VT Exam | Practice Questions & Answers
What is the maximum run for vapor piping? No maximum run
How you know a nozzle spout is bad. 'BAD O-rinqs
According to PEI RP 300, on a balance Stage II vapor The outside pathway
recovery system nozzle, Vapors typically flow in what
direction of the coaxial hose?
What is the maximum allowable number of P/V caps One
allowed on a UST fuel system?
On a Healy Air Separator, there are four Ball Valves, the One valve shall remain open on top
following shall be observed?
The Pressure settings for the UST Vent Cap is. .0+- 0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive Pressure
Given that in a balance Stage II vapor recovery system, From the outside pathway of the coaxial hose
the nozzle is equipped with a flexible nozzle bellows that
seals around the automobile fill pipe. This is how vapors
will typically flow.
The Healy 1301 flow limiter shall be used when the flow 10.0 GPM
rate exceeds this.
Given that: The VP1000 vacuum pump motor will operate 40 f (35f if 40f is not an option)
automatically when the temperature drops. The VP1000
will automatically operate when the temperature drops
below this temperature.
How do you verify a nozzle spout is bad and needs to be Test the nozzle
replaced?
Given that a "Classified Area" is a located where a fire and Extending 20 feet from dispensers to a height of 1.5 feet above ground
explosion hazard exists due to the presence of fuel vapors.
Because vapors are heavier than air In a Class I, Division
2 area, where may vapors be present
absorbent pads, and absorbent boom, fuel absorbet When responding to Fuel Spills, it is advisable to have the following equipment.
material
In accordance with PEI RP-500, a Level II Qualified Replace a Healy VP1000 Pump
Person may not perform what duty?
Volatile Organic Compounds VOC's
Grade A+ | Updated
Type of sealant you should you use on a Phil-Tite Ball Pipe dope
Float nipple:
Number of open valves on the clean air separator: One
You must be CERTIFIED by Healy to re-connect a Healy False
breakaway, True or False?
The type of pressure gauge is recommended to test Healy SYSA gauge measuring 0-100 WC
Vac
On new construction, after July 1, 2004, Can you install an YES-When Piping is monitored and with VAC
in-ground Spill Bucket?
According to Executive Order 201 - Healy P/V Valve 20-50 ft-lbs
should be torqued at
For a fire to burn, these (3) three primary elements must Fuel, Oxygen, Ignition Source
exist:
When working with Electrical - Lock Out Tag Out CAL-OSHA
procedures are under these guidelines.
Organization that certifies vapor recovery systems. CARB or ARB
According to RP 500, a level II technician may NOT Replace VP 1000 Healy Pump
inspect this part.
where hanging hardware repairs must be tracked. GDF maintenance log
approved sealant when assembling a Phil-Tite Drop Tube. JB-Kwik
Material direct bury OPW container sleeve shall be made Stainless steel
of.
What P/V vent cap shall be tightened to. 20-50 ft lbs
From dispenser to manifold - 2" diameter vapor piping ( 2" Vapor piping
ID) and From manifold to tank - 3" diameter vapor piping
(3" ID)
Grade A+ | Updated
, ICC Vapor Recovery VT Exam | Practice Questions & Answers
What is the maximum run for vapor piping? No maximum run
How you know a nozzle spout is bad. 'BAD O-rinqs
According to PEI RP 300, on a balance Stage II vapor The outside pathway
recovery system nozzle, Vapors typically flow in what
direction of the coaxial hose?
What is the maximum allowable number of P/V caps One
allowed on a UST fuel system?
On a Healy Air Separator, there are four Ball Valves, the One valve shall remain open on top
following shall be observed?
The Pressure settings for the UST Vent Cap is. .0+- 0.5inches H2O Negative Pressure 1,0+-2.0 inches H2O Positive Pressure
Given that in a balance Stage II vapor recovery system, From the outside pathway of the coaxial hose
the nozzle is equipped with a flexible nozzle bellows that
seals around the automobile fill pipe. This is how vapors
will typically flow.
The Healy 1301 flow limiter shall be used when the flow 10.0 GPM
rate exceeds this.
Given that: The VP1000 vacuum pump motor will operate 40 f (35f if 40f is not an option)
automatically when the temperature drops. The VP1000
will automatically operate when the temperature drops
below this temperature.
How do you verify a nozzle spout is bad and needs to be Test the nozzle
replaced?
Given that a "Classified Area" is a located where a fire and Extending 20 feet from dispensers to a height of 1.5 feet above ground
explosion hazard exists due to the presence of fuel vapors.
Because vapors are heavier than air In a Class I, Division
2 area, where may vapors be present
absorbent pads, and absorbent boom, fuel absorbet When responding to Fuel Spills, it is advisable to have the following equipment.
material
In accordance with PEI RP-500, a Level II Qualified Replace a Healy VP1000 Pump
Person may not perform what duty?
Volatile Organic Compounds VOC's
Grade A+ | Updated
