TRAFFIC SIGNAL TECHNICIAN Exam Questions and Verified Answers Graded A+
2026/27
What is the primary function of the IMSA? - Safety education
IMSA stands for: - International Municipal Signal Association
Which of the following is NOT an IMSA certification? - Y: Traffic Signal Level II
Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - Circular red, circular green
PPE stands for: - Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of aerial lift
equipment? - Full body harness
Safety belt
, Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - Ensure advance
warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - Y: Standards;
requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control
Signals: - Three-section traffic signal with circular red, circular yellow, and smaller
circular yellow indications
The following phases are typically assigned to the major street through movements: - 2
and 6
The green interval is made up which three components? - Minimum green, passage time,
maximum green
What are the three types of recall features of a traffic signal controller? - Minimum,
maximum, pedestrian (+soft)
2026/27
What is the primary function of the IMSA? - Safety education
IMSA stands for: - International Municipal Signal Association
Which of the following is NOT an IMSA certification? - Y: Traffic Signal Level II
Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - Circular red, circular green
PPE stands for: - Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the operation of aerial lift
equipment? - Full body harness
Safety belt
, Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - Ensure advance
warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - Y: Standards;
requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control
Signals: - Three-section traffic signal with circular red, circular yellow, and smaller
circular yellow indications
The following phases are typically assigned to the major street through movements: - 2
and 6
The green interval is made up which three components? - Minimum green, passage time,
maximum green
What are the three types of recall features of a traffic signal controller? - Minimum,
maximum, pedestrian (+soft)
