PSI Exam Study with question and answer 100 % correct
What is the primary purpose of using To prevent cracks from opening and to hold together cracks
Welded Wire Fabric (WWF) in concrete that occur between contraction joints.
slabs? 3 multiple choice options
What is the minimum aggregate clear 20 feet
egress width required for theaters?
3 multiple choice options
According to the International 34 inches
Building Code (IBC), what is the
3 multiple choice options
minimum height for guards on stairs?
What is a distinguishing feature of an The valley lining is exposed to the elements.
open valley in roof construction?
3 multiple choice options
During the manufacturing process of 2,200°F (1,204°C)
ceramic tiles, at what temperature is 3 multiple choice options
the bisque typically fired in a kiln?
, What is the general rule for stair Between 17 and 18 inches
design in terms of the sum of the 3 multiple choice options
riser height and
tread depth?
A commercial contractor is planning 49.05 kPa
the installation of a water containment
3 multiple choice options
system for a new building. The
system will be
located 5 meters below ground level.
Given the density of water is 1000
kg/mr and
gravitational acceleration is 9.81 m/s²,
what is the hydrostatic pressure at
the bottom of the containment
system?
In the design phase of a high-rise Concrete
residential building classified as Type
3 multiple choice options
I construction, which material would
be the safest choice for the main
support structures to ensure
compliance with fire and smoke
protection standards?
In a gypsum board installation, what is Apply the tape first, then apply the compound over it.
the
3 multiple choice options
correct sequence of applying joint tape
and compound?
When framing a non-load-bearing Wide dimension perpendicular to the wall
interior wall, how should studs be
3 multiple choice options
positioned to best support wall
finishes and ensure wall stability?
A contractor needs to select treated Marine Use - 2.50 pcf
wood for a freshwater dock where
3 multiple choice options
the wood will be partially
submerged. Which of the
following treatment levels and
corresponding pcf values is
most appropriate for this
application?
According to the International 1.5 inches
Building Code (IBC), what is the
3 multiple choice options
minimum bearing
requirement for wood floor joists on a
wood beam?
What is the minimum yield strength 50 ksi
for 54 mil steel or thicker used in
3 multiple choice options
cold-formed metal framing?
Which type of finish creates a Film-Forming Finishes
protective layer on the surface of
3 multiple choice options
the material and is popular for its
What is the primary purpose of using To prevent cracks from opening and to hold together cracks
Welded Wire Fabric (WWF) in concrete that occur between contraction joints.
slabs? 3 multiple choice options
What is the minimum aggregate clear 20 feet
egress width required for theaters?
3 multiple choice options
According to the International 34 inches
Building Code (IBC), what is the
3 multiple choice options
minimum height for guards on stairs?
What is a distinguishing feature of an The valley lining is exposed to the elements.
open valley in roof construction?
3 multiple choice options
During the manufacturing process of 2,200°F (1,204°C)
ceramic tiles, at what temperature is 3 multiple choice options
the bisque typically fired in a kiln?
, What is the general rule for stair Between 17 and 18 inches
design in terms of the sum of the 3 multiple choice options
riser height and
tread depth?
A commercial contractor is planning 49.05 kPa
the installation of a water containment
3 multiple choice options
system for a new building. The
system will be
located 5 meters below ground level.
Given the density of water is 1000
kg/mr and
gravitational acceleration is 9.81 m/s²,
what is the hydrostatic pressure at
the bottom of the containment
system?
In the design phase of a high-rise Concrete
residential building classified as Type
3 multiple choice options
I construction, which material would
be the safest choice for the main
support structures to ensure
compliance with fire and smoke
protection standards?
In a gypsum board installation, what is Apply the tape first, then apply the compound over it.
the
3 multiple choice options
correct sequence of applying joint tape
and compound?
When framing a non-load-bearing Wide dimension perpendicular to the wall
interior wall, how should studs be
3 multiple choice options
positioned to best support wall
finishes and ensure wall stability?
A contractor needs to select treated Marine Use - 2.50 pcf
wood for a freshwater dock where
3 multiple choice options
the wood will be partially
submerged. Which of the
following treatment levels and
corresponding pcf values is
most appropriate for this
application?
According to the International 1.5 inches
Building Code (IBC), what is the
3 multiple choice options
minimum bearing
requirement for wood floor joists on a
wood beam?
What is the minimum yield strength 50 ksi
for 54 mil steel or thicker used in
3 multiple choice options
cold-formed metal framing?
Which type of finish creates a Film-Forming Finishes
protective layer on the surface of
3 multiple choice options
the material and is popular for its
