Technician Occupations Selection System Exam | 2026/2027 Latest Updated Version | Questions And Verified Answers | Graded A+

TECHNICIAN OCCUPATIONS SELECTION SYSTEM EXAM |
2026/2027 LATEST UPDATED VERSION | QUESTIONS AND VERIFIED
ANSWERS | GRADED A+


In the figure shown m what DMMfunction? -
CORRECT|ANSWER

C



When taking a resistance measurement -
CORRECT|ANSWER

A- remove the resistor from the cricut



To measure total voltage in a here phase -
CORRECT|ANSWER

D- phase A and B, phase A and C, phase B and C



A voltage tested placed across -
CORRECT|ANSWER

B- there is an open auxiliary contact



The first range you should select when using a multimeter is.. -
CORRECT|ANSWER

C- Highest



To measure current to a 3 phase Ac motor -
CORRECT|ANSWER

A- Incorrect the jaws should be shut



Before using a digital multimeter -
CORRECT|ANSWER

B- Disconnect the resister from the circuit

, What does the programmable logic control -
CORRECT|ANSWER

B- The processor is running and all is ready to operate



What is e function of thermocouple after the motor starter output is on? -
CORRECT|ANSWER

B- measure temperature



To prevent electrostatic discharge damage -
CORRECT|ANSWER

C- Ensure the equipment is grounded



Basically, the function of a pic is -
CORRECT|ANSWER

D- make logical decisions and provide outputs



If a pic indicates a fault condition, to clear the fault -
CORRECT|ANSWER

D- Check the fuse on the input boards



Which of the following device -
CORRECT|ANSWER

C- thermocouple



An indicator light that is controlled by a programmable -
CORRECT|ANSWER

C- power supple



In the circuit shown, at what points should your voltage -
CORRECT|ANSWER

D- X2 and X4 with start button depressed