vehicle communication system | UPDATED Questions with 100% Verified Answers

vehicle communication system | UPDATED Questions with 100%
Verified Answers

Question:
what is the resistance of the terminating resistor on networks
equipped with one start connector?

Answer:
60 ohms


Question:
with the bus active and no faults present, what voltages
should be measured on CAN-C(+)?

Answer:
approximately 3.2v


Question:
what Atlantis-high network uses splice block connectors?

Answer:
CAN-BH


Question:
with the bus active and no faults present, what voltages
should be measured on CAN-B(-)?

Answer:
approximately 0.4v


Question:
which resource should be used first for troubleshooting DRB
III Emulator concerns?

Answer:
wiTECH knowledge base


Question:

, with the bus active and no faults present, what voltages
should be measured on LIN?

Answer:
7.0v-10.0v


Question:
what electrical architecture requires the use of the mopar
diagnostic pod (MPD) for diagnostics?

Answer:
Atlantis-high


Question:
which of the following scan tool functions ate prevented if a
security gateway (SGW) becomes locked? select all that
apply.

Answer:
start an actuator
run a system test
flash program a module


Question:
with the bus active and no faults present, what voltages
should be measured on CAN-C(-)?

Answer:
approximately 1.8v


Question:
what Atlantis vehicles uses splice block connectors on their
CAN buses? select all that apply.

Answer:
ga alfa glulia
mp jeep compass


Question: