NCCCO Overhead Crane Test
Questions and Correct Answers
Graded A+ 100% Complete
Guaranteed Verified by Experts
1. Overhead cranes with more than one hoisting unit shall have?
A) Its own daily inspection.
B) Its rated load marked on it.
C) A wind-indicating device.
D) Automatic rail clamps.: B) Its rated load marked on it.
2. What is the purpose the "E" (Emergency) stop on an overhead
crane?
A) Removes power to hoists only.
B) Removes power to entire bridge.
C) Removes power to trolley only.
D) Removes power to entire crane.: D) Removes power to entire crane.
3. How often does O.S.H.A require a written wire rope inspection?
A) Once a shift.
B) Once a week.
,C) Once a month.
D) Once a quarter.: C) Once a month.
4. Most loads should be rigged to within how many degrees of level?
A) Two.
B) Three.
C) Four.
D) Five.: D) Five.
5. According to ASME B30.2, what is the safety factor for rigging?
A) 3 to 1
B) 4 to 1
C) 5 to 1
D) 6 to 1: C) 5 to 1
6. According to O.S.H.A frequent inspections shall be performed.
A) Monthly to annually.
B) Daily to monthly.
C) Hourly to daily.
D) Daily to weekly.: B) Daily to monthly.
7. According to ASME B30.2 a frequent inspection must be
performed by?
,A) Competent person.
B) Designated person.
C) Qualified person.
D) Authorized person.: B) Designated person.
8. According to ASME B30.2, the maximum twist of the hook can't
exceed?
A) 10*
B) 0*
C) 15*
D) 20*: B) 0*
9. When inspecting electrical contacts, what are the signs they are
bad?
A) Pitted or burned.
B) Discolored.
C) Springs are taut.
10. Makes sparks.: A) Pitted or burned.
11. According to ASME B30.2, what type of fire extinguisher is
required for overhead cranes?
A) 5BS
B) 10BC
, C) 5C
D) 10A: B) 10BC
12. Before leaving an overhead crane unattended, attached loads
should be?
A) Raised to the upper limit point.
B) Raised just above the floor.
C) Lowered to the floor.
D) Unhooked from the crane.: C) Lowered to the floor.
13. Before using your hand to steady any load, you should?
A) Follow company policies.
B) Wear approved gloves.
C) Follow foreman's direction.
D) Wear approved hard hat.: A) Follow company policies.
14. According to OSHA, the rated capacity of all overhead cranes
shall be?
A) Clearly marked on the side of the crane.
B) Filed in supervisors office.
C) Clearly marked on shipping papers.
D) Filed in crane owners office.: A) Clearly marked on the side of the crane.
Questions and Correct Answers
Graded A+ 100% Complete
Guaranteed Verified by Experts
1. Overhead cranes with more than one hoisting unit shall have?
A) Its own daily inspection.
B) Its rated load marked on it.
C) A wind-indicating device.
D) Automatic rail clamps.: B) Its rated load marked on it.
2. What is the purpose the "E" (Emergency) stop on an overhead
crane?
A) Removes power to hoists only.
B) Removes power to entire bridge.
C) Removes power to trolley only.
D) Removes power to entire crane.: D) Removes power to entire crane.
3. How often does O.S.H.A require a written wire rope inspection?
A) Once a shift.
B) Once a week.
,C) Once a month.
D) Once a quarter.: C) Once a month.
4. Most loads should be rigged to within how many degrees of level?
A) Two.
B) Three.
C) Four.
D) Five.: D) Five.
5. According to ASME B30.2, what is the safety factor for rigging?
A) 3 to 1
B) 4 to 1
C) 5 to 1
D) 6 to 1: C) 5 to 1
6. According to O.S.H.A frequent inspections shall be performed.
A) Monthly to annually.
B) Daily to monthly.
C) Hourly to daily.
D) Daily to weekly.: B) Daily to monthly.
7. According to ASME B30.2 a frequent inspection must be
performed by?
,A) Competent person.
B) Designated person.
C) Qualified person.
D) Authorized person.: B) Designated person.
8. According to ASME B30.2, the maximum twist of the hook can't
exceed?
A) 10*
B) 0*
C) 15*
D) 20*: B) 0*
9. When inspecting electrical contacts, what are the signs they are
bad?
A) Pitted or burned.
B) Discolored.
C) Springs are taut.
10. Makes sparks.: A) Pitted or burned.
11. According to ASME B30.2, what type of fire extinguisher is
required for overhead cranes?
A) 5BS
B) 10BC
, C) 5C
D) 10A: B) 10BC
12. Before leaving an overhead crane unattended, attached loads
should be?
A) Raised to the upper limit point.
B) Raised just above the floor.
C) Lowered to the floor.
D) Unhooked from the crane.: C) Lowered to the floor.
13. Before using your hand to steady any load, you should?
A) Follow company policies.
B) Wear approved gloves.
C) Follow foreman's direction.
D) Wear approved hard hat.: A) Follow company policies.
14. According to OSHA, the rated capacity of all overhead cranes
shall be?
A) Clearly marked on the side of the crane.
B) Filed in supervisors office.
C) Clearly marked on shipping papers.
D) Filed in crane owners office.: A) Clearly marked on the side of the crane.
