AIT ALBERTA WELDING FIRST YEAR FINAL
TEST EXAM LATEST 2026/2027 ALL STUDY
QUESTIONS WITH VERIFIED ANSWERS
GUARANTEED PASS RATED A+
, AIT ALBERTA WELDING FIRST YEAR FINAL TEST EXAM
LATEST 2026/2027 ALL STUDY QUESTIONS WITH VERIFIED
ANSWERS GUARANTEED PASS RATED A+
What height limitation is in place when using freestanding scaffolding? - Answer>>> For free
standing scaffolds, the scaffold must not be taller than three (3) times its smallest dimension in
height
Where the rigging was assembled or fabricated by the employer, what percent of the ultimate
breaking strength of the weakest component must the working load not exceed if the rigging is
used to support workers? - Answer>>> 10%
Which of the following is incorrect. Specifications on drawings may contain this type of
information. - Answer>>> Type of filler metal used
What is the duty to use personal protective equipment according to the Alberta OHS Code? -
Answer>>> What you and your employer must do if a hazard assessment identifies the need for
the use of PPE
What is the characteristic of protective footwear with a yellow triangle on the outer side or
tounge of the right shoe? - Answer>>> Sole puncture protection and Grade 2 protective toe (will
withstand impact up to 90 Joules)
When installing clips, the saddle side of the clip must be placed on the: - Answer>>> Live side
of the wire
When balancing a No. 2 welding tip and the acetylene torch needle valve is fully open, the
acetylene regulator should be adjusted so that the flame blows away from the tip _______ inch.
(Oxygen needle valve is closed) - Answer>>> 1/4
Which ferrous-based metals cannot be cut satisfactorily with an oxy-fuel cutting torch? -
Answer>>> stainless
What is the total number of hours in the first period Welder Training Profile? - Answer>>> 240
TEST EXAM LATEST 2026/2027 ALL STUDY
QUESTIONS WITH VERIFIED ANSWERS
GUARANTEED PASS RATED A+
, AIT ALBERTA WELDING FIRST YEAR FINAL TEST EXAM
LATEST 2026/2027 ALL STUDY QUESTIONS WITH VERIFIED
ANSWERS GUARANTEED PASS RATED A+
What height limitation is in place when using freestanding scaffolding? - Answer>>> For free
standing scaffolds, the scaffold must not be taller than three (3) times its smallest dimension in
height
Where the rigging was assembled or fabricated by the employer, what percent of the ultimate
breaking strength of the weakest component must the working load not exceed if the rigging is
used to support workers? - Answer>>> 10%
Which of the following is incorrect. Specifications on drawings may contain this type of
information. - Answer>>> Type of filler metal used
What is the duty to use personal protective equipment according to the Alberta OHS Code? -
Answer>>> What you and your employer must do if a hazard assessment identifies the need for
the use of PPE
What is the characteristic of protective footwear with a yellow triangle on the outer side or
tounge of the right shoe? - Answer>>> Sole puncture protection and Grade 2 protective toe (will
withstand impact up to 90 Joules)
When installing clips, the saddle side of the clip must be placed on the: - Answer>>> Live side
of the wire
When balancing a No. 2 welding tip and the acetylene torch needle valve is fully open, the
acetylene regulator should be adjusted so that the flame blows away from the tip _______ inch.
(Oxygen needle valve is closed) - Answer>>> 1/4
Which ferrous-based metals cannot be cut satisfactorily with an oxy-fuel cutting torch? -
Answer>>> stainless
What is the total number of hours in the first period Welder Training Profile? - Answer>>> 240
