NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
1. Type ____ is multiconductor cable identified for use as Type USE cable
underground service entrance cable.
2. Knife switch rated for more than 1200 Amps at Can be used only as iso-
250Volts or less lating switch, shall not be
opened under load
3. Track lighting with outlets in a bathroom is not al- Track lighting has recepta-
lowed because ? cle
4. Where internal combustion engines are used as the 6 hours
prime motor, an on site fuel supply shall be provided
with an on premise fuel supply sufficient for not less
than ____ hours full demand operation of the system
5. Fixed in place X-ray equipment properly supplied by a 30 Amps
branch circuit rated at not over ____ amperes shall be
permitted to be supplied through a suitable attach-
ment plug cap and hard service cable cord.
6. Where skin effect exist the ferromagnetic envelope Both ends
shall be bonded at ____.
7. GFCI protection at a carnival is not required for equip- Locking
ment at circuit if the receptacle is of the ____type.
8. The maximum voltage drop from service point to the 4%
last over-current device in a dwelling unit?
9. Which of the following statements best describe the Accessible non current
grounding requirement for central vacuum outlet carrying metal parts are
required to be connected
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
to an equipment ground-
ing conductor.
10. In healthcare facilities, patient bed receptacles locat- Are permitted
ed in general care areas shall be supplied by at least
two branch circuits, which ____permitted to originate
from two separate transfer switches on the emer-
gency system
11. Patient care areas of healthcare facilities ____ ar- Do not include
eas such as business offices, corridors, lounges ,day
rooms, or similar areas
12. The patient care area is any portion of the healthcare Examined or treated
facility where patients are intended to be ____or ____.
13. Each general care area patient bed location in a Single or two
healthcare facility must be provided with four ____ or
____ duplex receptacles
14. A hospital is a building or portion thereof used for Four
medical, psychiatric,obstetrical , or surgical, care on a
24 hour basis of ____ or more patients
15. Where installed to reduce electrical noise for elec- Listed fitting
tronic equipment, electrical continuity of the metal
raceways shall not be required and metal raceway can
terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment
16. Feeder and branch circuit conductors within ____ inch- 3 inches
es of a Ballast shall have an insulation temperature
rating not lower than 90°C (194°F) unless supplying a
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
luminaiere marked as suitable for a different insula-
tion temperature
17. Manufactured wiring systems constructed with type 6 ft
MC cable shall be supported and secured at intervals
not exceeding ____ ft.
18. Where a main bonding jumper or a system bonding Green finish
jumper is a screw only the screw shall be identified
with a ____ that shall be visible with the screw installed
19. Plug fuses a 15 amperes and lower rating shall be Hexagon
identified by a ____ configuration of the window, cap,
or other prominent part to distinguish them from fus-
es of higher ampere rating
20. The load for household electric clothes dryer's in a 5000 watts
dwelling unit(s) shall be either ____ watts (volt-am-
peres) or the nameplate rating, which ever is larger,
for each dryer served ?
21. Service conductors installed as unjacketed multicon- 3 ft (36 inches)
ductor cable shall have a minimum clearance of ____
windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations.
22. —— Cartridge fuses of the renewable type shall be Class H
permitted to be used only for replacement in existing
installation is where there is no evidence of over-fus-
ing or tampering.
23. 3" inches
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
Branch circuit conductors within ____inches of the bal-
last shall have an insulation temperature rating not
lower it 90°C 194°F
24. The minimum radius of a field bend on trade size 1 8
"1/4 RMC is ____.
25. In a dwelling unit which appliance is allowed to have Combination range
a 24"inch cord with Attachment ground plug ? hood/microwave oven
26. Type 3 Surge Protective devices can be installed on Included in the manufac-
the load side of a branch circuit overcurrent device tures instructions
up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a
distance from the service or separately derived sys-
tem disconnect
27. Which flexible cable is Allowed to be used for electric EVJ
vehicle charging station 300 Volts ?
28. Type ____ fuse adapters shall be designed so that once Type S fuse
inserted in a fuse holder that cannot be removed
29. Service drops Installed over roof shall have a vertical 8'ft
clearance of ____ above the roof surface, and unless a
lesser distance is permitted by and exceptions
30. Class 2 and Class 3 circuits shall not be placed in any Separated by barrier
enclosure, raceway, cable, or similar fittings with con-
ductors of Class 1 or electric light or power conduc-
tors, unless ____.
31. 3 duplex (6 single)
Study online at https://quizlet.com/_6x5xx9
1. Type ____ is multiconductor cable identified for use as Type USE cable
underground service entrance cable.
2. Knife switch rated for more than 1200 Amps at Can be used only as iso-
250Volts or less lating switch, shall not be
opened under load
3. Track lighting with outlets in a bathroom is not al- Track lighting has recepta-
lowed because ? cle
4. Where internal combustion engines are used as the 6 hours
prime motor, an on site fuel supply shall be provided
with an on premise fuel supply sufficient for not less
than ____ hours full demand operation of the system
5. Fixed in place X-ray equipment properly supplied by a 30 Amps
branch circuit rated at not over ____ amperes shall be
permitted to be supplied through a suitable attach-
ment plug cap and hard service cable cord.
6. Where skin effect exist the ferromagnetic envelope Both ends
shall be bonded at ____.
7. GFCI protection at a carnival is not required for equip- Locking
ment at circuit if the receptacle is of the ____type.
8. The maximum voltage drop from service point to the 4%
last over-current device in a dwelling unit?
9. Which of the following statements best describe the Accessible non current
grounding requirement for central vacuum outlet carrying metal parts are
required to be connected
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
to an equipment ground-
ing conductor.
10. In healthcare facilities, patient bed receptacles locat- Are permitted
ed in general care areas shall be supplied by at least
two branch circuits, which ____permitted to originate
from two separate transfer switches on the emer-
gency system
11. Patient care areas of healthcare facilities ____ ar- Do not include
eas such as business offices, corridors, lounges ,day
rooms, or similar areas
12. The patient care area is any portion of the healthcare Examined or treated
facility where patients are intended to be ____or ____.
13. Each general care area patient bed location in a Single or two
healthcare facility must be provided with four ____ or
____ duplex receptacles
14. A hospital is a building or portion thereof used for Four
medical, psychiatric,obstetrical , or surgical, care on a
24 hour basis of ____ or more patients
15. Where installed to reduce electrical noise for elec- Listed fitting
tronic equipment, electrical continuity of the metal
raceways shall not be required and metal raceway can
terminate a (an) ____ nonmetallic fitting or spacer on
electronic equipment
16. Feeder and branch circuit conductors within ____ inch- 3 inches
es of a Ballast shall have an insulation temperature
rating not lower than 90°C (194°F) unless supplying a
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
luminaiere marked as suitable for a different insula-
tion temperature
17. Manufactured wiring systems constructed with type 6 ft
MC cable shall be supported and secured at intervals
not exceeding ____ ft.
18. Where a main bonding jumper or a system bonding Green finish
jumper is a screw only the screw shall be identified
with a ____ that shall be visible with the screw installed
19. Plug fuses a 15 amperes and lower rating shall be Hexagon
identified by a ____ configuration of the window, cap,
or other prominent part to distinguish them from fus-
es of higher ampere rating
20. The load for household electric clothes dryer's in a 5000 watts
dwelling unit(s) shall be either ____ watts (volt-am-
peres) or the nameplate rating, which ever is larger,
for each dryer served ?
21. Service conductors installed as unjacketed multicon- 3 ft (36 inches)
ductor cable shall have a minimum clearance of ____
windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations.
22. —— Cartridge fuses of the renewable type shall be Class H
permitted to be used only for replacement in existing
installation is where there is no evidence of over-fus-
ing or tampering.
23. 3" inches
, NYC MASTER ELECTRICIAN EXAM
Study online at https://quizlet.com/_6x5xx9
Branch circuit conductors within ____inches of the bal-
last shall have an insulation temperature rating not
lower it 90°C 194°F
24. The minimum radius of a field bend on trade size 1 8
"1/4 RMC is ____.
25. In a dwelling unit which appliance is allowed to have Combination range
a 24"inch cord with Attachment ground plug ? hood/microwave oven
26. Type 3 Surge Protective devices can be installed on Included in the manufac-
the load side of a branch circuit overcurrent device tures instructions
up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a
distance from the service or separately derived sys-
tem disconnect
27. Which flexible cable is Allowed to be used for electric EVJ
vehicle charging station 300 Volts ?
28. Type ____ fuse adapters shall be designed so that once Type S fuse
inserted in a fuse holder that cannot be removed
29. Service drops Installed over roof shall have a vertical 8'ft
clearance of ____ above the roof surface, and unless a
lesser distance is permitted by and exceptions
30. Class 2 and Class 3 circuits shall not be placed in any Separated by barrier
enclosure, raceway, cable, or similar fittings with con-
ductors of Class 1 or electric light or power conduc-
tors, unless ____.
31. 3 duplex (6 single)
