New York State Crane Written Exam 2026/2027 | 28 Questions & Correct Answers | Crane Safety, Rigging, Wire Rope, Power Lines & OSHA

New York State Crane Written Exam 2026/2027 is a focused 6-page crane examination study resource containing 28 questions and correct answers covering crane operation, lifting safety, rigging, wire-rope inspection, operational aids, outriggers, electrical hazards, hoisting procedures, and equipment shutdown. The document is structured as direct exam questions with answers and focuses on practical concepts that crane operators need to recognize when preparing for a New York State crane written examination. A major section covers crane operating principles and safe load handling. The material addresses the principle of leverage, dynamic loading, parts of line, high-wind conditions, and smooth, controlled crane operation. It explains that erratic or sudden load movement should be avoided and discusses how load size, shape, weight, and wind conditions can influence whether lifting operations should continue. The document gives particular attention to wire rope, hoisting equipment, and rigging safety. Questions address kinking, bird-caging, broken-wire criteria in running ropes, minimum rope wraps on a drum, hook requirements, and thimbles in wire-rope sling eyes. Before hoisting, the material instructs candidates to check that the hoist rope is not kinked, the hook is directly over the load, parts of line are not twisted, the rope is seated correctly on the drum and sheaves, and weather conditions are acceptable. Another central topic is anti-two-blocking protection and crane operational aids. The resource explains two-blocking as contact between the hook block or headache ball and the sheaves at the boom head, extension, or jib tip, with the potential to damage the hoist rope and cause the block or ball to fall. It also reviews operational aids such as load-weight or load-moment indicators, boom-angle indicators, and anti-two-blocking devices. The safety section covers crane setup, outriggers, blocking, and ground conditions. Candidates review relieving the crane's weight from the tires during the setup described in the material, keeping blocking level, positioning outrigger pads appropriately, and comparing the bearing capacity of gravel, sand, clay, and silt. The document also includes a Class F line truck/digger derrick question involving maximum weight and boom height. A particularly important portion addresses power-line hazards and operator safety. The material specifies a clearance for operations near high-voltage power lines up to 50 kV and discusses what operators should do following crane contact with an energized line. It also covers safe mounting and dismounting through three-point contact. Because electrical-contact emergencies can be life-threatening, candidates should use this document as exam-preparation material and verify operational procedures against their current employer safety program and applicable official regulations rather than treating a study answer as field-specific emergency instruction. The final section reviews inspection requirements, unattended-crane procedures, and mechanical systems. Topics include the inspection described in the material for cranes idle for three or more months, landing suspended loads before leaving a crane unattended, disengaging the master clutch, placing controls in neutral, setting brakes and locking devices, preventing accidental travel, shutting off the engine, and identifying the master cylinder as the component where hydraulic pressure is built up in the braking system. Relevant Students: New York State crane written exam candidates, crane operator license candidates, mobile crane operators, hoisting machine operator candidates, construction equipment operators, rigging students, line truck and digger derrick operators, crane apprentices, heavy-equipment operators, construction safety students, and workers reviewing crane operation, wire-rope inspection, rigging, outriggers, power-line safety, OSHA-related inspection concepts, and safe hoisting practices. Keywords: New York State Crane Written Exam, New York crane exam , NYS crane written exam, New York crane exam questions and answers, crane operator practice test, crane written test, crane operator license exam, crane safety exam, crane operation questions, crane rigging exam, anti two blocking device, two blocking crane, crane load moment indicator, boom angle indicator, principle of leverage crane, dynamic loading crane, parts of line, crane wind limits, wire rope inspection, wire rope kinking, wire rope bird caging, broken wires in running rope, crane operational aids, crane outrigger setup, outrigger blocking, power line clearance crane, crane electrical safety, three point contact, crane hoisting procedures, minimum rope wraps, crane hook latch, wire rope sling thimbles, crane inspection requirements, OSHA crane inspection, unattended crane procedures, digger derrick, Class F line truck, crane operator study guide, New York crane practice exam