Red seal plumber alberta canada Exam Review latest
2026 Update
Radon piping in order MFG manometer, fan and gooseneck
Temporary Platform Scaffolding erected must have3.5 m
toeboards install when the scaffolding is more than m above the
ground.
Horizontally run ¾" type M copper pipe must be2.5 meters supported every:
Water that is determined to have a PH of 5.5 would bemildly acidic considered:
Dielectric unions are used to: prevent corrosion
When installing glass piping; if one end needs to be fieldbead to plain cut, the
ends should be joined:
What force would be exerted on the gate of a closed 6"1300 gate
valve if the water pressure acting on it measured 46 Psig.
Asbestos cement pipe installed below a 60 mm thick600mm concrete floor
must be at least how deep?
The discharge from a sump pump shall have the followingunion, check valve, shut-off valve fittings
installed in order, in the direction of flow:
When a well pump turns on as soon as a faucet is usedwater logged pressure tank the most
likely problem is:
A gear pump is a positive displacement pump and mustpressure relief valve be
installed with a:
What type of trap is not permitted in a drainage system: bell trap
, Which backflow preventer is not a testable device? DCAP
Where is the jet located in a deep well? above the foot valve
How would you increase the length of flush on aturn regulating screw counter clockwise flushometer?
Six equally spaced lav's are to be installed along a wall177cm that is
530 cm long and will be vented with dual vents. Determine the
center to center distance between vents if the fixtures are each 51 cm
wide.
A 3" drainage pipe (1/4" per ft) suspended from a ceiling25.2"
inside a building at it most upstream end is 7.5" from the ceiling to
the center of the pipe. What will the measurement be from the
ceiling to the center of the pipe if it travels 26 feet horizontally,
has an 8 foot horizontal offset then continues another 37 feet.
What is the minimum length of a trap arm? 2 pipe diameters
A branch with 34 fixture units discharges into a sewage3" sump.
What is the minimum size vent required for the sump?
A building's roof measuring 90m by 50m would require5 how
many flow controlled roof drains?
The absorption rate of a septic field is determined by: percolation test
Determine the amount of expansion that will occur when59.4 mm a 15m
ABS pipe has a temperature change of 40ºC. EXPANSION RATE OF ABS is
.000099 in Celsius
Length is not a consideration when sizing this vent: header
A cross fitting may not be used in a DWV system exceptfour vents to
connect:
A ½" extracted tee may be formed from: ¾" Type K
2026 Update
Radon piping in order MFG manometer, fan and gooseneck
Temporary Platform Scaffolding erected must have3.5 m
toeboards install when the scaffolding is more than m above the
ground.
Horizontally run ¾" type M copper pipe must be2.5 meters supported every:
Water that is determined to have a PH of 5.5 would bemildly acidic considered:
Dielectric unions are used to: prevent corrosion
When installing glass piping; if one end needs to be fieldbead to plain cut, the
ends should be joined:
What force would be exerted on the gate of a closed 6"1300 gate
valve if the water pressure acting on it measured 46 Psig.
Asbestos cement pipe installed below a 60 mm thick600mm concrete floor
must be at least how deep?
The discharge from a sump pump shall have the followingunion, check valve, shut-off valve fittings
installed in order, in the direction of flow:
When a well pump turns on as soon as a faucet is usedwater logged pressure tank the most
likely problem is:
A gear pump is a positive displacement pump and mustpressure relief valve be
installed with a:
What type of trap is not permitted in a drainage system: bell trap
, Which backflow preventer is not a testable device? DCAP
Where is the jet located in a deep well? above the foot valve
How would you increase the length of flush on aturn regulating screw counter clockwise flushometer?
Six equally spaced lav's are to be installed along a wall177cm that is
530 cm long and will be vented with dual vents. Determine the
center to center distance between vents if the fixtures are each 51 cm
wide.
A 3" drainage pipe (1/4" per ft) suspended from a ceiling25.2"
inside a building at it most upstream end is 7.5" from the ceiling to
the center of the pipe. What will the measurement be from the
ceiling to the center of the pipe if it travels 26 feet horizontally,
has an 8 foot horizontal offset then continues another 37 feet.
What is the minimum length of a trap arm? 2 pipe diameters
A branch with 34 fixture units discharges into a sewage3" sump.
What is the minimum size vent required for the sump?
A building's roof measuring 90m by 50m would require5 how
many flow controlled roof drains?
The absorption rate of a septic field is determined by: percolation test
Determine the amount of expansion that will occur when59.4 mm a 15m
ABS pipe has a temperature change of 40ºC. EXPANSION RATE OF ABS is
.000099 in Celsius
Length is not a consideration when sizing this vent: header
A cross fitting may not be used in a DWV system exceptfour vents to
connect:
A ½" extracted tee may be formed from: ¾" Type K
