A third 90 degree bend may be permitted in a conduit run 10m
if the run does NOT exceed ______ ?
which of the following is a property of an electromagnetic Inductance
field built around a conductor that opposes any changes
in current flow in a circuit?
Which of the following markings is used for non- OFNG
conductive optical fiber general purpose cables?
Which of the following refers to a set of rules issued by a Regulations
governmental body at the state level within the US?
What is the specified performance level for category 6 250MHz
cable?
Which type of optical fiber cable should be color coded MM with a 100 um core diameter
with an Orange outer cable sheath?
Which of the following is the primary benefit of using Takes up less space within the equipment room
wall-mounted racks and cabinets in place of traditional
equipment racks?
Which topology uses a linear configuration that places all Bus
network devices on one length of cable?
Which of the TWO organizations jointly oversee the ISO & IEC
worldwide standardization of telecommunications
cabling?
Which of the following is a building-serving space that ER
houses large pieces of common active equipment?
Which phase of testing includes documenting the test Phase 3
results?
Which of the following is designed to provide protection Rubber Gloves
from harmful chemicals?
Which of the following are typically used to support J-Hook
cables between a cable tray and work area outlets?
Which of the following PPE items MUST be worn at all Eye protection
times when you are working with or handling OF?
Which of the following is used to equalize potential BBC
differences between the SBB on the same floor?
Which type of optical fiber cable should be color coded Dispersion-shifted SM optical fiber
with a RED outer cable sheath?
, BICSI Installer 1 Exam Review | Complete Practice Questions & Verified Answers
Which of the following connector styles is presently used Small form factor (SFF)
within optical fiber cabling systems (i.e., it is NOT a
legacy connector)?
Which of the following components is used to bond the TBC
electrical system's grounding electrode system to the
PBB?
What is the characteristic impedance of Series-6 coaxial 75 ohms
cable?
Which of the following makes the biggest impression on Choice of words
a customer when you are communicating via email?
Which of the following attachment methods does BICSI Compression
recommend for attaching coaxial connectors to coaxial
cable?
Electrical power (P) is measured in ___________? Watts
During a retrofit, an installation crew discovers old Stop work immediately
insulation that they think may contain asbestos, they
cannot complete their work without disturbing the
insulation. What is the best course of action for the crew
to take?
What is the maximum allowable horizontal cable length? 90 m
Which of the following describes a nonmechanical Ablative
firestop system that forms a hard char when exposed to
flame?
How much cable slack should be left in the work area 1m (3.3')
after termination?
Which of the following types of cable produces very little LSZH
smoke when burned?
How much sheath of the cable needs to be removed in 12.7mm (0.5")
order to properly terminate an 8P8C?
Two truck drivers are communicating over a Citizens Half-duplex
Band (CB) radio. Only one driver can send a message at
a time with this system. What type of transmission
method is used in this example?
Which tool is required to pull backbone cable of Tugger
significant weight?
What is the primary purpose of firestopping? Reestablish the barrier's fire rating