J-STD-001 Soldering Certification Exam Study Guide

1 | Page




J-STD-001 EXAM QUESTIONS
AND CORRECT VERIFIED
ANSWERS GRADED A+ LATEST
EXAM UPDATE
D


Who is responsible for identifying the assembly class? - ✔✔✔
O


Correct Answer > User
N
O
T


What is a defect? - ✔✔✔ Correct Answer > A condition that may affect the
form, fit, or function of the item in the end use environment
C
O
PY


Hardware found to not conform to the requirements of the standard shall
be classified as defects and dispositioned for: -
✔✔✔ Correct Answer > [D1D2D3]



There shall be no broken strands for wires used at a potential of 6kV or
greater: - ✔✔✔ Correct Answer > [D1D2D3]


A documented process control system shall be implemented for: - ✔✔✔
Correct Answer > [N1N2D3]

, 2 | Page




The contract shall take precedence over this standard for: - ✔✔✔
Correct Answer > [D1D2D3]

What is wire overlap? - ✔✔✔ Correct Answer > When a wire is wrapped
more than 360 and crosses over itself


What is wire over wrap? - ✔✔✔ Correct Answer > When a wire is wrapped
D


more than 360 and remains in contact with the terminal
O
N
O


Manufacturers shall perform 100% inspection unless sampling
T


inspection is defined for: - ✔✔✔ Correct Answer > [N1D2D3]
C
O


Inspection of soldering and cleanliness shall be performed prior to
PY


conformal coasting, staking, or encapsulation for: - ✔✔✔ Correct Answer >
[N1D2D3]


Illumination at the surface of work stations should be at least what? -
✔✔✔ Correct Answer > 1000 lux




What is the tolerance for magnification aids? - ✔✔✔ Correct Answer > +-
15%