ELECTRICAL CRAFT HELPER EXAM WITH
CORRECT ACTUAL QUESTIONS AND CORRECTLY
WELL DEFINED ANSWERS LATEST ALREADY
GRADED A+
Play your way to mastery with fun games
Match Blocks Charms NEW
Practice questions for this set
Learn 1 /7 Study with Learn
which is best to use to remove nuts or bolts?
Choose an answer
1 offset 2 rate of flow of electric current
3 reamer 4 open end wrench
, Don't know?
Terms in this set (42)
offset screwdriver especially good for use in cramped
spaces
hook-spanner wrench wrench best used on a round nut which has a series
of notches cut in the outer edge
screw extractor an "easy out" is also known as
diagonal-cutting pliers best pliers for cutting a small-gauge wire end off
close to the terminal is a pair of
reamer which tool most likely used to smooth out the inside
of a pipe that has been sawed off
right both when reaming and when reaming a hole, the reamer should be turned
withdrawing to the
teeth will mar the nut best reason for not using slip-joint pliers for
loosening or tightening nuts is that the
box-end wrench which wrench is best to use for removing nuts where
only a short pull of the wrench is possible?
CORRECT ACTUAL QUESTIONS AND CORRECTLY
WELL DEFINED ANSWERS LATEST ALREADY
GRADED A+
Play your way to mastery with fun games
Match Blocks Charms NEW
Practice questions for this set
Learn 1 /7 Study with Learn
which is best to use to remove nuts or bolts?
Choose an answer
1 offset 2 rate of flow of electric current
3 reamer 4 open end wrench
, Don't know?
Terms in this set (42)
offset screwdriver especially good for use in cramped
spaces
hook-spanner wrench wrench best used on a round nut which has a series
of notches cut in the outer edge
screw extractor an "easy out" is also known as
diagonal-cutting pliers best pliers for cutting a small-gauge wire end off
close to the terminal is a pair of
reamer which tool most likely used to smooth out the inside
of a pipe that has been sawed off
right both when reaming and when reaming a hole, the reamer should be turned
withdrawing to the
teeth will mar the nut best reason for not using slip-joint pliers for
loosening or tightening nuts is that the
box-end wrench which wrench is best to use for removing nuts where
only a short pull of the wrench is possible?
