Progression: Field Tech II - III Conventional ACTUAL EXAM &
PRACTICE EXAM 2026 || MOST RECENT EXAM 2026|2027 ACTUAL
COMPLETE REAL EXAM QUESTIONS AND CORRECT ANSWERS
(VERIFIED ANSWERS) ALREADY GRADED A+ | GUARANTEED
SUCCESS!! BRAND NEW VERSION! | JUST RELEASED!!
What are the three main conditions that influence the range of a
wireless local area network (WLAN)? - ANSWER-Transmission
power, antenna type and location, and environment.
What can be done to increase the coverage area of a wireless
local area network (WLAN)? - ANSWER-Increase the
transmission power, replace the omnidirectional antenna with a
parabolic antenna, and use the 2.4 GHz radio band instead of
the 5 GHz radio band.
What initialization vector (IV) do most weak implementations of
the Wireless Equivalency Protocol (WEP) use? - ANSWER-24
bit.
How can filtering augment some of the security limitations of
Wired Equivalent Privacy (WEP) in a wireless local area
network (WLAN)? - ANSWER-By defining parameters to which
client stations must adhere in order to gain access to the
network.
Which term describes a wireless system in which the access
point (AP) removes the wireless local area networks (WLAN)
,service set identifier (SSID) from the beacon frames? -
ANSWER-Closed system.
Wireless local area networks (WLAN) that use an IEEE 802.1x
protocol control network access on what basis? - ANSWER-
Port based.
Access points (AP) must support what encryption techniques
in order to comply with IEEE 802.11i security standards? -
ANSWER-Temporal Key Integrity Protocol (TKIP), Advanced
Encryption Standard (AES), and AES-CCMP (Counter-
Mode/CBC-MAC Protocol).
What is a man-in-the-middle attack on a wireless local area
network (WLAN)? - ANSWER-A situation in which a hacker uses
an access point (AP) to effectively hijack mobile nodes (clients)
by sending a stronger signal than the legitimate AP is sending.
What type of wireless local area network (WLAN) attack could
cost an employee their job because network usage logs point
directly to the employee whenever a hacker gains access to the
employee's domain login information and causes havoc on the
network? - ANSWER-A passive attack.
How might a wireless local area network (LAN) administrator
ensure compliance with security audits? - ANSWER-Document
audit procedures in the security policy.
,For maximum security, you should base your wireless local
area network (WLAN) user authentication on which one of the
following? - ANSWER-Device-independent schemes, such as
user names and passwords.
To prevent hacker access to passwords and Internet protocol
(IP) addresses, why would you want to place wireless access
points (AP) on switches instead of hubs? - ANSWER-Switches
prevent the broadcast of packets to all network segments.
What are some basic questions you should ask a customer
before visiting the customer's facility to perform a site survey?
- ANSWER-The anticipated number of users, security
requirements, data throughput requirements, and budget.
What information should you gather during the wireless local
area network (WLAN) site survey in a convention center for an
upcoming trade show? - ANSWER-Identify who will be
installing access points (AP) in ceilings that could be 40 feet
high.
What test should you perform during the site survey to enable
the design engineer to understand and control what the user's
experience will be on the wireless local area network (WLAN)? -
ANSWER-A data throughput test.
Why is it suggested that all data collected as part of a site
survey for a wireless local area network (WLAN) be included in
the survey report as an attachment, appendix, or separate set
, of documentation? - ANSWER-The data could be needed in the
future.
What are some of the access points (AP) facts that should be
detailed in a wireless local area network (WLAN) site survey? -
ANSWER-Location within facility, antenna type to be used,
power output settings, how power will be provided to unit, and
the expected data throughput per unit
Ideally, what should your next step be after you complete the
wireless local area network (WLAN) site survey and provide the
survey results in a report to the customer? - ANSWER-A
wireless consulting firm should be given the site survey report
so that it will then be able to provide effective information on
equipment purchasing and security solutions.
What should you note in the wireless local area network
(WLAN) site survey if a semi directional antenna is required for
adequate coverage? - ANSWER-The antenna orientation along
with the antenna's side and back lobes for coverage and
security reasons.
What are some desired features of an access point (AP) used to
perform wireless local area network (WLAN) site surveys? -
ANSWER-Variable output power and external antenna
connectors.
How would you use a laptop computer, tablet, or cell phone
when performing a site survey for a wireless local area network
PRACTICE EXAM 2026 || MOST RECENT EXAM 2026|2027 ACTUAL
COMPLETE REAL EXAM QUESTIONS AND CORRECT ANSWERS
(VERIFIED ANSWERS) ALREADY GRADED A+ | GUARANTEED
SUCCESS!! BRAND NEW VERSION! | JUST RELEASED!!
What are the three main conditions that influence the range of a
wireless local area network (WLAN)? - ANSWER-Transmission
power, antenna type and location, and environment.
What can be done to increase the coverage area of a wireless
local area network (WLAN)? - ANSWER-Increase the
transmission power, replace the omnidirectional antenna with a
parabolic antenna, and use the 2.4 GHz radio band instead of
the 5 GHz radio band.
What initialization vector (IV) do most weak implementations of
the Wireless Equivalency Protocol (WEP) use? - ANSWER-24
bit.
How can filtering augment some of the security limitations of
Wired Equivalent Privacy (WEP) in a wireless local area
network (WLAN)? - ANSWER-By defining parameters to which
client stations must adhere in order to gain access to the
network.
Which term describes a wireless system in which the access
point (AP) removes the wireless local area networks (WLAN)
,service set identifier (SSID) from the beacon frames? -
ANSWER-Closed system.
Wireless local area networks (WLAN) that use an IEEE 802.1x
protocol control network access on what basis? - ANSWER-
Port based.
Access points (AP) must support what encryption techniques
in order to comply with IEEE 802.11i security standards? -
ANSWER-Temporal Key Integrity Protocol (TKIP), Advanced
Encryption Standard (AES), and AES-CCMP (Counter-
Mode/CBC-MAC Protocol).
What is a man-in-the-middle attack on a wireless local area
network (WLAN)? - ANSWER-A situation in which a hacker uses
an access point (AP) to effectively hijack mobile nodes (clients)
by sending a stronger signal than the legitimate AP is sending.
What type of wireless local area network (WLAN) attack could
cost an employee their job because network usage logs point
directly to the employee whenever a hacker gains access to the
employee's domain login information and causes havoc on the
network? - ANSWER-A passive attack.
How might a wireless local area network (LAN) administrator
ensure compliance with security audits? - ANSWER-Document
audit procedures in the security policy.
,For maximum security, you should base your wireless local
area network (WLAN) user authentication on which one of the
following? - ANSWER-Device-independent schemes, such as
user names and passwords.
To prevent hacker access to passwords and Internet protocol
(IP) addresses, why would you want to place wireless access
points (AP) on switches instead of hubs? - ANSWER-Switches
prevent the broadcast of packets to all network segments.
What are some basic questions you should ask a customer
before visiting the customer's facility to perform a site survey?
- ANSWER-The anticipated number of users, security
requirements, data throughput requirements, and budget.
What information should you gather during the wireless local
area network (WLAN) site survey in a convention center for an
upcoming trade show? - ANSWER-Identify who will be
installing access points (AP) in ceilings that could be 40 feet
high.
What test should you perform during the site survey to enable
the design engineer to understand and control what the user's
experience will be on the wireless local area network (WLAN)? -
ANSWER-A data throughput test.
Why is it suggested that all data collected as part of a site
survey for a wireless local area network (WLAN) be included in
the survey report as an attachment, appendix, or separate set
, of documentation? - ANSWER-The data could be needed in the
future.
What are some of the access points (AP) facts that should be
detailed in a wireless local area network (WLAN) site survey? -
ANSWER-Location within facility, antenna type to be used,
power output settings, how power will be provided to unit, and
the expected data throughput per unit
Ideally, what should your next step be after you complete the
wireless local area network (WLAN) site survey and provide the
survey results in a report to the customer? - ANSWER-A
wireless consulting firm should be given the site survey report
so that it will then be able to provide effective information on
equipment purchasing and security solutions.
What should you note in the wireless local area network
(WLAN) site survey if a semi directional antenna is required for
adequate coverage? - ANSWER-The antenna orientation along
with the antenna's side and back lobes for coverage and
security reasons.
What are some desired features of an access point (AP) used to
perform wireless local area network (WLAN) site surveys? -
ANSWER-Variable output power and external antenna
connectors.
How would you use a laptop computer, tablet, or cell phone
when performing a site survey for a wireless local area network
