MINNESOTA MOBILE CRANE OPERATOR CERTIFICATION
EXAM – 2026/2027 COMPLETE (140) CURRENT TESTING
QUESTIONS AND CORRECT ANSWERS WITH DETAILED
RATIONALES.
CRANE
Prepare for the Minnesota Mobile Crane Operator Certification Exam with this focused
practice resource designed to support your licensing and certification preparation. It
features exam-style practice questions covering OSHA 1926 Subpart CC crane safety
standards, load chart calculations, boom length and radius geometry, setup and
outrigger positioning, ground conditions, hand signals and communications, wire rope
inspection and rigging, power line safety clearances, and Minnesota OSHA (MNOSHA)
compliance. An ideal study aid for mobile crane operators, equipment technicians,
and safety supervisors looking to demonstrate technical proficiency and pass their
state certification exam.
MULTIPLE CHOICE.
SECTION 1: MINNESOTA REGULATIONS AND STATUTORY REQUIREMENTS
(Questions 1-15)
1. Under Minnesota Statute § 182.6525, what is the minimum lifting
capacity that requires a crane operator to hold a valid certificate?
A) 1 ton
B) 3 tons
C) 5 tons
D) 10 tons
Answer: C
Rationale: Minnesota Statute § 182.6525 requires certification for any
crane with a lifting capacity of five tons or more operating on a
construction site.
, Page 2 of 52
2. How often must a crane operator certification be renewed in
Minnesota?
A) Every 2 years
B) Every 3 years
C) Every 5 years
D) Every 10 years
Answer: C
Rationale: Minnesota law requires crane operator certifications to be
renewed every five years by an accredited certification program.
3. Which organizations are recognized for crane operator certification in
Minnesota?
A) Only the Minnesota Department of Labor and Industry
B) Nationally recognized and accredited certification programs (such as
NCCCO)
C) Any private training company
D) Only OSHA
Answer: B
Rationale: Minnesota law requires certification from a nationally
recognized and accredited certification program. NCCCO (National
Commission for the Certification of Crane Operators) is the primary
recognized body.
4. Who is prohibited from permitting an individual to operate a crane
without proper certification?
A) Only the crane operator
B) No employer or general contractor may permit uncertified operation
, Page 3 of 52
C) Only the site supervisor
D) Only the equipment owner
Answer: B
Rationale: Minnesota law states that no employer or general contractor
may permit an individual to operate a crane unless the employee has a
valid crane operator certificate.
5. What is the statutory authority for crane operator certification in
Minnesota?
A) Minnesota Statute § 182.6525
B) Minnesota Statute § 326B.90
C) Minnesota Rule 1307.0090
D) OSHA 1926 Subpart CC
Answer: A
Rationale: Minnesota Statute § 182.6525 specifically addresses crane
operation certification requirements in the state.
6. In Minnesota, the OSHA 1926 Subpart CC standards for crane operator
training and certification:
A) Are not enforced in Minnesota
B) Replaced state standards to align Minnesota with federal OSHA
requirements
C) Only apply to tower cranes
D) Are optional for employers
Answer: B
Rationale: Minnesota aligned its crane operator standards with the 2018
federal OSHA standards for crane operator training and certification to put
MNOSHA in line with similar OSHA programs in other states.
, Page 4 of 52
7. A crane with a lifting capacity of 4.5 tons operating on a Minnesota
construction site:
A) Requires full NCCCO certification
B) Does not require certification under state law
C) Requires a special state-issued permit
D) Requires only a training certificate
Answer: B
Rationale: Minnesota law requires certification only for cranes with a
lifting capacity of five tons or more. A 4.5-ton crane falls below this
threshold.
8. What is the penalty for operating a crane without proper certification in
Minnesota?
A) No penalty
B) A warning only
C) Civil money penalties may be imposed
D) Criminal charges only
Answer: C
Rationale: Minnesota law authorizes civil money penalties for violations
of crane operator certification requirements.
9. Who has the authority to authorize crane operator certification
programs in Minnesota?
A) The Governor
B) The Commissioner of Labor and Industry
C) The Minnesota Legislature