AHIT Final Exam
Study online at https://quizlet.com/_7rtr2l
1. When should the home inspector not re- if the inspector gets a shock upon touching it
move the cover (dead-front) to the main
panel?
2. What is a subpanel? a panel that adds more circuits to the service
3. When inspecting the fuses or breakers, compare amperage rating of fuse or breaker
the home inspector should _____. to connected branch wiring
4. Where is the home inspector likely to find in homes built during the mid-1960s to
aluminum branch circuit wiring? mid-1970s
5. ***Electrical receptacles should be pre- every 12' along interior walls
sent _____.***
6. According to most standards, the home operate all GFCIs
inspector is required to _____.
7. ***What is a split receptacle?*** one that has a complete circuit for each half
of the receptacle
8. How do the standards describe the in- as a visual inspection
spection of a home's electrical system?
9. What is resistance? opposition of a material to the flow of elec-
tricity
10. What is the measure for electromotive volts
force?
11. ***What is the most highly recommend- using COPALUM crimp connectors to bond
ed method of repairing aluminum branch copper to the aluminum wiring at every con-
circuit wiring?*** nection and splice
, AHIT Final Exam
Study online at https://quizlet.com/_7rtr2l
12. What wire gauge should the service con- #4 copper or #2 aluminum
ductors be for a 100-amp electrical ser-
vice?
13. What can be the cause of driveway up- tree roots
heaval?
14. Which of the following should be report- balusters too far apart
ed as a safety hazard?
15. Why should sources of ignition be raised it keeps the ignition sources away from gaso-
18" off the floor? line vapors
16. When the solvent in paint evaporates too alligatoring
quickly, what can be the result?
17. What would not be a cause of a sliding a leaking seal in the window
glass door rubbing during operation?
18. What is the definition of a porch? a roofed extension of the house
19. What is the proper pitch for a patio? pitched away from the house
20. The most common retaining wall failure inadequate drainage
is caused by _____.
21. The main problem with stucco is that it tends to crack
_____.
22. How should the corner moldings on alu- the upper molding overlapping the one be-
minum siding be installed? low
23. A hinged door that rubs the frame during loose hinge screws
operation may have _____.
Study online at https://quizlet.com/_7rtr2l
1. When should the home inspector not re- if the inspector gets a shock upon touching it
move the cover (dead-front) to the main
panel?
2. What is a subpanel? a panel that adds more circuits to the service
3. When inspecting the fuses or breakers, compare amperage rating of fuse or breaker
the home inspector should _____. to connected branch wiring
4. Where is the home inspector likely to find in homes built during the mid-1960s to
aluminum branch circuit wiring? mid-1970s
5. ***Electrical receptacles should be pre- every 12' along interior walls
sent _____.***
6. According to most standards, the home operate all GFCIs
inspector is required to _____.
7. ***What is a split receptacle?*** one that has a complete circuit for each half
of the receptacle
8. How do the standards describe the in- as a visual inspection
spection of a home's electrical system?
9. What is resistance? opposition of a material to the flow of elec-
tricity
10. What is the measure for electromotive volts
force?
11. ***What is the most highly recommend- using COPALUM crimp connectors to bond
ed method of repairing aluminum branch copper to the aluminum wiring at every con-
circuit wiring?*** nection and splice
, AHIT Final Exam
Study online at https://quizlet.com/_7rtr2l
12. What wire gauge should the service con- #4 copper or #2 aluminum
ductors be for a 100-amp electrical ser-
vice?
13. What can be the cause of driveway up- tree roots
heaval?
14. Which of the following should be report- balusters too far apart
ed as a safety hazard?
15. Why should sources of ignition be raised it keeps the ignition sources away from gaso-
18" off the floor? line vapors
16. When the solvent in paint evaporates too alligatoring
quickly, what can be the result?
17. What would not be a cause of a sliding a leaking seal in the window
glass door rubbing during operation?
18. What is the definition of a porch? a roofed extension of the house
19. What is the proper pitch for a patio? pitched away from the house
20. The most common retaining wall failure inadequate drainage
is caused by _____.
21. The main problem with stucco is that it tends to crack
_____.
22. How should the corner moldings on alu- the upper molding overlapping the one be-
minum siding be installed? low
23. A hinged door that rubs the frame during loose hinge screws
operation may have _____.
