NICET LEVEL 1 Exam Questions With Accurate
Answers 2025\2026 A+ Grade
4 wires
- accurate answers-what is the maximum number of 14 AWG RHH conductors
which can be installed in 1/2 rigid metal conduit?
3.5'-48" to the actuator
- accurate answers-Which of the following would be an appropriate mounting
height for a pull station?
1 flash per second
- accurate answers-What is the minimum flash rate for a visible notification
device?
90" to the top of the device
- accurate answers-What is the minimum mounting height for audible
notification devices?
Such that the entire lens is not less then 80"
- accurate answers-What is the minimum mounting height for visible
notification devices?
Voltage=Current X Resistence
- accurate answers-What is the formula for Ohm's Law
Put your meter in series with the circuit
- accurate answers-When using your mult-meter to measure, you must:
Semi-annually
- accurate answers-Waterflow devices shall be tested with that frequency?
Annually
- accurate answers-With what frequency shall ionization smoke detectors be
given a functional test?
24 hours in normal operation, 5 minutes in alarm
- accurate answers-What are the standby power requirements for a
proprietary signaling system?
, Shunt type
- accurate answers-Which of the following is a type of auxiliary protective
signaling system?
A UL listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
- accurate answers-Remote station signaling systems are permitted to send
signals to:
600V
- accurate answers-Non-power limited fire alarm cable shall have an
insulation rating of:
20,000 CFM HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
- accurate answers-Which of these HVAC systems would require duct
detectors on supply and return?
Group A, E, F
- accurate answers-According to the IBC, which of the following use Groups
require visual notification?
Every 4 hours
- accurate answers-Digital Alarm communicator transmitters (DACT) which
use call forwarding to the DACR shall be tested with what frequency?
True
- accurate answers-When connecting 4 wires smoke detectors to a fire alarm
system, the power conductors shall be monitored for integrity.
Smoke detectors shall be permitted to use 30 foot spacing as a guide
- accurate answers-Which of the following is true regarding smoke detector
spacing?
A slope of greater than 1 in 8
- accurate answers-A slope ceiling is defined as:
Answers 2025\2026 A+ Grade
4 wires
- accurate answers-what is the maximum number of 14 AWG RHH conductors
which can be installed in 1/2 rigid metal conduit?
3.5'-48" to the actuator
- accurate answers-Which of the following would be an appropriate mounting
height for a pull station?
1 flash per second
- accurate answers-What is the minimum flash rate for a visible notification
device?
90" to the top of the device
- accurate answers-What is the minimum mounting height for audible
notification devices?
Such that the entire lens is not less then 80"
- accurate answers-What is the minimum mounting height for visible
notification devices?
Voltage=Current X Resistence
- accurate answers-What is the formula for Ohm's Law
Put your meter in series with the circuit
- accurate answers-When using your mult-meter to measure, you must:
Semi-annually
- accurate answers-Waterflow devices shall be tested with that frequency?
Annually
- accurate answers-With what frequency shall ionization smoke detectors be
given a functional test?
24 hours in normal operation, 5 minutes in alarm
- accurate answers-What are the standby power requirements for a
proprietary signaling system?
, Shunt type
- accurate answers-Which of the following is a type of auxiliary protective
signaling system?
A UL listed central station
A receiver located at an unlisted monitoring facility
A fire department or communications center
- accurate answers-Remote station signaling systems are permitted to send
signals to:
600V
- accurate answers-Non-power limited fire alarm cable shall have an
insulation rating of:
20,000 CFM HVAC system serving a single floor
15,000 CFM HVAC system serving 3 floors
20,000 CFM HVAC system serving 2 floors
- accurate answers-Which of these HVAC systems would require duct
detectors on supply and return?
Group A, E, F
- accurate answers-According to the IBC, which of the following use Groups
require visual notification?
Every 4 hours
- accurate answers-Digital Alarm communicator transmitters (DACT) which
use call forwarding to the DACR shall be tested with what frequency?
True
- accurate answers-When connecting 4 wires smoke detectors to a fire alarm
system, the power conductors shall be monitored for integrity.
Smoke detectors shall be permitted to use 30 foot spacing as a guide
- accurate answers-Which of the following is true regarding smoke detector
spacing?
A slope of greater than 1 in 8
- accurate answers-A slope ceiling is defined as:
