NICET Level 1 Inspection & Testing Exam
Questions With Correct Solutions 2025\2026 A+
Grade
When using a pulse load tester on a sealed lead acid battery, the minimum
acceptable capacity is...
- accurate answers-80%
When a software change is made to a fire alarm system, what percentage of
the initiating devices not affected by the change must be tested
- accurate answers-10%
When testing elevator recall, the elevator should go to the alternate level
when:
- accurate answers-The lobby smoke detector on the recall level is activated
Minimum requirement for system documentation
- accurate answers-Battery calculations/floor plan/sequence of
operations/voltage drop calculations
Carbon monoxide detectors used for the toxicity of gas fired heating
equipment must be tested annually per NFPA 72
- accurate answers-False
What is the maximum time period to replace a lead acid battery
- accurate answers-Per manufacturers recommendation
What type of instrument is normally used to test the specific gravity of lead
acid battery cells
- accurate answers-Hydrometer
Requirements of the branch circuit for the fire alarm control panel
- accurate answers-Must be identified as fire alarm circuit.....must have a red
marking......must be locked in the ON position if its a circuit breaker
A ladder must be able to support ....... Times the weight of the anticipated load
- accurate answers-3.3 times
, Periodic testing records are required to be maintained for?
- accurate answers-One year after the next test
The term "approved" in NFPA 72 refers to approved by:
- accurate answers-The AHJ
In areas that are not continually occupied, automatic smoke detection shall be
provided at?
- accurate answers-Location of the FACP......location of the remote power
supplies for notification appliances......supervising station communication
equipment
NFPA72 recommends this to be specified in the test plan
- accurate answers-What is to be tested......how it is to be tested
Where monitoring of room temperature is required to detect freezing for a
wet pipe sprinkler system, what should the temperature setting?
- accurate answers-40 degrees
When testing a water level switch for a pressurized storage tank, what is the
proper setting?
- accurate answers-+/-3 inches
Two 12 volt 10 amp-hour batteries are connected in series. What is the
resulting output voltage and amp hour capacity?
- accurate answers-24 volts 10 amp-hours
A non-restorable heat detector must:
- accurate answers-Be replaced after actuating
The standard evacuation signal is a three pulse temporal pattern consisting of:
- accurate answers-3 pulses of 1/2 second ON, 1/2 second OFF, and a 1.5
second OFF phase
A smoke detector that reflects light off of the smoke to a sensor uses the [.........]
operating principle
- accurate answers-Light scattering
Questions With Correct Solutions 2025\2026 A+
Grade
When using a pulse load tester on a sealed lead acid battery, the minimum
acceptable capacity is...
- accurate answers-80%
When a software change is made to a fire alarm system, what percentage of
the initiating devices not affected by the change must be tested
- accurate answers-10%
When testing elevator recall, the elevator should go to the alternate level
when:
- accurate answers-The lobby smoke detector on the recall level is activated
Minimum requirement for system documentation
- accurate answers-Battery calculations/floor plan/sequence of
operations/voltage drop calculations
Carbon monoxide detectors used for the toxicity of gas fired heating
equipment must be tested annually per NFPA 72
- accurate answers-False
What is the maximum time period to replace a lead acid battery
- accurate answers-Per manufacturers recommendation
What type of instrument is normally used to test the specific gravity of lead
acid battery cells
- accurate answers-Hydrometer
Requirements of the branch circuit for the fire alarm control panel
- accurate answers-Must be identified as fire alarm circuit.....must have a red
marking......must be locked in the ON position if its a circuit breaker
A ladder must be able to support ....... Times the weight of the anticipated load
- accurate answers-3.3 times
, Periodic testing records are required to be maintained for?
- accurate answers-One year after the next test
The term "approved" in NFPA 72 refers to approved by:
- accurate answers-The AHJ
In areas that are not continually occupied, automatic smoke detection shall be
provided at?
- accurate answers-Location of the FACP......location of the remote power
supplies for notification appliances......supervising station communication
equipment
NFPA72 recommends this to be specified in the test plan
- accurate answers-What is to be tested......how it is to be tested
Where monitoring of room temperature is required to detect freezing for a
wet pipe sprinkler system, what should the temperature setting?
- accurate answers-40 degrees
When testing a water level switch for a pressurized storage tank, what is the
proper setting?
- accurate answers-+/-3 inches
Two 12 volt 10 amp-hour batteries are connected in series. What is the
resulting output voltage and amp hour capacity?
- accurate answers-24 volts 10 amp-hours
A non-restorable heat detector must:
- accurate answers-Be replaced after actuating
The standard evacuation signal is a three pulse temporal pattern consisting of:
- accurate answers-3 pulses of 1/2 second ON, 1/2 second OFF, and a 1.5
second OFF phase
A smoke detector that reflects light off of the smoke to a sensor uses the [.........]
operating principle
- accurate answers-Light scattering
