4TH CLASS POWER ENGINEERING UNIT A12
CHAPTER 4: FEED WATER SYSTEMS ALREADY
PASSED
Ethane is a component of natural gas and constitutes a percent
volume of:
(a) 10 - 20%
(b) 80 - 90%
(c) 60 - 70%
(d) 5 - 10%
(a) 10 - 20%
Deaerators are classified as pressure vessels and are divided
into which 2 distinct sections:
(a) Condensate and water sections
(b) Water and steam sections
(c) Heater and storage sections
(d) Make up water and feedwater sections
(c) Heater and storage sections
Code states that feedwater piping must be designed for
pressures exceeding the boiler's MAWP by:
Page 1 of 99
,(a) 1 1/2 times or 1550 kpa, whichever is less
(b) 25% or 1550 kpa, whichever is less
(c) 3% or 150 kpa, whichever is less
(d) 3% above the highest setting of the relief valves
(b) 25% or 1550 kpa, whichever is less
The simplest way of measuring draft is with:
(a) a "U" tube manometer
(b) a Bourdon tube device
(c) a flexible diaphragm device
(d) a hydrometer
(a) a "U" tube manometer
A boiler blow down system is equipped with slow and fast
opening valves. The quick opening valve is placed:
(a) closest to the boiler and opened first
(b) furthest from the boiler and opened first
(c) closest to the boiler and opened last
(d) furthest from the boiler and opened last
(a) closest to the boiler and opened first
Page 2 of 99
,When heat demand is very low, the Two Fixed Capacity
Burner system will:
(a) cycle the primary burner
(b) cycle the secondary burner
(c) stop the secondary fuel pump
(d) close the primary solenoid valve
(a) cycle the primary burner
With an axial flow fan the air flow:
(a) is at right angles to the windbox
(b) is at right angles to the shaft
(c) does not come in contact with the driving motor
(d) is parallel to the shaft
(d) is parallel to the shaft
Brick and mortar stack requires
(a) no maintenance
(b) linings of steel reinforcement
(c) fire brick or clay lining
(d) less height than steel stacks
Page 3 of 99
, (c) fire brick or clay lining
Which of the following is not a function of a steam deaerator?
(a) To preheat feedwater and lessen the thermal shock at the
boiler
(b) To act as storage for reserve feedwater
(c) To remove dissolved gases from the feedwater
(d) To allow for separation of dissolved solids from the
feedwater
(d) To allow for separation of dissolved solids from the
feedwater
Which of the following is not a component of a condensate
return system?
(a) Condensate receiver
(b) Condensate pump
(c) Condensate make-up tank
(d) Condensate return lines
(c) Condensate make-up tank
The function of a low water fuel cut-off is to
Page 4 of 99
CHAPTER 4: FEED WATER SYSTEMS ALREADY
PASSED
Ethane is a component of natural gas and constitutes a percent
volume of:
(a) 10 - 20%
(b) 80 - 90%
(c) 60 - 70%
(d) 5 - 10%
(a) 10 - 20%
Deaerators are classified as pressure vessels and are divided
into which 2 distinct sections:
(a) Condensate and water sections
(b) Water and steam sections
(c) Heater and storage sections
(d) Make up water and feedwater sections
(c) Heater and storage sections
Code states that feedwater piping must be designed for
pressures exceeding the boiler's MAWP by:
Page 1 of 99
,(a) 1 1/2 times or 1550 kpa, whichever is less
(b) 25% or 1550 kpa, whichever is less
(c) 3% or 150 kpa, whichever is less
(d) 3% above the highest setting of the relief valves
(b) 25% or 1550 kpa, whichever is less
The simplest way of measuring draft is with:
(a) a "U" tube manometer
(b) a Bourdon tube device
(c) a flexible diaphragm device
(d) a hydrometer
(a) a "U" tube manometer
A boiler blow down system is equipped with slow and fast
opening valves. The quick opening valve is placed:
(a) closest to the boiler and opened first
(b) furthest from the boiler and opened first
(c) closest to the boiler and opened last
(d) furthest from the boiler and opened last
(a) closest to the boiler and opened first
Page 2 of 99
,When heat demand is very low, the Two Fixed Capacity
Burner system will:
(a) cycle the primary burner
(b) cycle the secondary burner
(c) stop the secondary fuel pump
(d) close the primary solenoid valve
(a) cycle the primary burner
With an axial flow fan the air flow:
(a) is at right angles to the windbox
(b) is at right angles to the shaft
(c) does not come in contact with the driving motor
(d) is parallel to the shaft
(d) is parallel to the shaft
Brick and mortar stack requires
(a) no maintenance
(b) linings of steel reinforcement
(c) fire brick or clay lining
(d) less height than steel stacks
Page 3 of 99
, (c) fire brick or clay lining
Which of the following is not a function of a steam deaerator?
(a) To preheat feedwater and lessen the thermal shock at the
boiler
(b) To act as storage for reserve feedwater
(c) To remove dissolved gases from the feedwater
(d) To allow for separation of dissolved solids from the
feedwater
(d) To allow for separation of dissolved solids from the
feedwater
Which of the following is not a component of a condensate
return system?
(a) Condensate receiver
(b) Condensate pump
(c) Condensate make-up tank
(d) Condensate return lines
(c) Condensate make-up tank
The function of a low water fuel cut-off is to
Page 4 of 99