1|Page
OSHA 10 Construction And General
Industry Final Exam Questions And
Verified Answers 2026
When fall arrest equipment is used, employers must assure that _________.
A. A rescue plan is in place to rescue a fallen employee
B. Users have calculated total fall distance
C. All equipment is properly inspected before each use
D. All of the above - correct- answer-D. All of the above
Excavations over 6 feet deep and not obviously visible must, at minimum, be
A. Protected by guardrails
B. Barricaded or marked
C. Covered with traffic plates
D. No protection is required - correct- answer-B. Barricaded or marked
, 2|Page
Ground Fault Circuit Interrupters (GFCI) are required by the National Electrical
Code:
A. On all temporary power circuits
B. When there are wet conditions
C. On portable generators over 5,000 watts
D. All of the above - correct- answer-D. All of the above
Many forklift accidents happen because the operator does which of the following:
A. Uses broken equipment
B. Carries an unsafe load
C. Travels an unsafe route
D. All of the above - correct- answer-D. All of the above
Full set of 390 OSHA 10 Answers
https://www.oyetrade.com/OSHA-10-Answers-2021.php
OSHA 10 Construction And General
Industry Final Exam Questions And
Verified Answers 2026
When fall arrest equipment is used, employers must assure that _________.
A. A rescue plan is in place to rescue a fallen employee
B. Users have calculated total fall distance
C. All equipment is properly inspected before each use
D. All of the above - correct- answer-D. All of the above
Excavations over 6 feet deep and not obviously visible must, at minimum, be
A. Protected by guardrails
B. Barricaded or marked
C. Covered with traffic plates
D. No protection is required - correct- answer-B. Barricaded or marked
, 2|Page
Ground Fault Circuit Interrupters (GFCI) are required by the National Electrical
Code:
A. On all temporary power circuits
B. When there are wet conditions
C. On portable generators over 5,000 watts
D. All of the above - correct- answer-D. All of the above
Many forklift accidents happen because the operator does which of the following:
A. Uses broken equipment
B. Carries an unsafe load
C. Travels an unsafe route
D. All of the above - correct- answer-D. All of the above
Full set of 390 OSHA 10 Answers
https://www.oyetrade.com/OSHA-10-Answers-2021.php
