Illinois Roofing Exam
Study online at https://quizlet.com/_51bwk1
1. How many eaves does a gable roof have ? 2
2. How many rakes does a gable roof have ? 4
3. Does a hip roof have any rakes ? No
4. How many hips does a hipped roof have ? 4
5. How many eves are on a hipped roof? 4
6. Eave A projecting edge of a roof that ex-
tends beyond the supporting wall.
7. Rake The sloped edge fo a gable roof
8. Hip The inclined external angle of formed
by the two sloping sides of a hip roof.
9. Ridge The highest point on the roof repre-
sented by horizontal line where two
roof areas intersect.
10. Slope The incline angle of a roof surface ex-
pressed as a ratio of the rise of the
roof to the run of the roof, expressed
in inches.
11. A 45 degree angle is a slope of 12:12
12. What makes a roof assembly ? A roof deck plus the roof system.
13. Which of these is NOT among the purposes of Provide waterproofing and moisture
a roof deck? control
14.
, Illinois Roofing Exam
Study online at https://quizlet.com/_51bwk1
Which of the following is a non stationary load An installers mobile equipment up on
that a roof deck must be able to support? the roof.
15. What is the purpose of light weight insulated To form or fill or provide insulation.
concrete?
16. Which type of concrete is designed to hold Structural concrete.
weight?
17. Which type of decking withholds most mois- OSB
ture?
18. Why does the NRCA recommend replacing Their tendency to hold moisture can
composite roof deck made of laminated insu- lead to dimensional changes and fas-
lation & OSB? tener back out.
19. When you are installing a wood deck made of The thickness of the wood material
boards,planks,plywood,or OSB, which of the is based on the design loads of the
following is the most accurate statement ? building.
20. Which statement most likely accurately de- The proper thickness of wood materi-
scribes wood plank and wood panels decks? al is determined by the design of the
loads.
21. Which statement most accurately describes A system that is matched to building
the best roofing systems? specifications and characteristics.
22. How should the reinforcement component of Embedded between layers of water-
a built-up roof system installed? proofing material.
23. While heating up the bitumen material in a Circulate the bitumen material on a
kettle on the jobsite, which of the following regular basis while the heating is go-
should you do? ing on.
Study online at https://quizlet.com/_51bwk1
1. How many eaves does a gable roof have ? 2
2. How many rakes does a gable roof have ? 4
3. Does a hip roof have any rakes ? No
4. How many hips does a hipped roof have ? 4
5. How many eves are on a hipped roof? 4
6. Eave A projecting edge of a roof that ex-
tends beyond the supporting wall.
7. Rake The sloped edge fo a gable roof
8. Hip The inclined external angle of formed
by the two sloping sides of a hip roof.
9. Ridge The highest point on the roof repre-
sented by horizontal line where two
roof areas intersect.
10. Slope The incline angle of a roof surface ex-
pressed as a ratio of the rise of the
roof to the run of the roof, expressed
in inches.
11. A 45 degree angle is a slope of 12:12
12. What makes a roof assembly ? A roof deck plus the roof system.
13. Which of these is NOT among the purposes of Provide waterproofing and moisture
a roof deck? control
14.
, Illinois Roofing Exam
Study online at https://quizlet.com/_51bwk1
Which of the following is a non stationary load An installers mobile equipment up on
that a roof deck must be able to support? the roof.
15. What is the purpose of light weight insulated To form or fill or provide insulation.
concrete?
16. Which type of concrete is designed to hold Structural concrete.
weight?
17. Which type of decking withholds most mois- OSB
ture?
18. Why does the NRCA recommend replacing Their tendency to hold moisture can
composite roof deck made of laminated insu- lead to dimensional changes and fas-
lation & OSB? tener back out.
19. When you are installing a wood deck made of The thickness of the wood material
boards,planks,plywood,or OSB, which of the is based on the design loads of the
following is the most accurate statement ? building.
20. Which statement most likely accurately de- The proper thickness of wood materi-
scribes wood plank and wood panels decks? al is determined by the design of the
loads.
21. Which statement most accurately describes A system that is matched to building
the best roofing systems? specifications and characteristics.
22. How should the reinforcement component of Embedded between layers of water-
a built-up roof system installed? proofing material.
23. While heating up the bitumen material in a Circulate the bitumen material on a
kettle on the jobsite, which of the following regular basis while the heating is go-
should you do? ing on.
