NEIEP 100 EXAM SCRIPT PREMIUM
REVIEW SHEET TESTED QUESTIONS AND
ANSWERS
●● How to turn Lbs to Kg
Answer: Divide by 2.2
●● Wheat types of detail drawings would you expect to see on a elevator
installation job
Answer: Standardized, electrical, structural and hoistway drawings
●● Installing hoistway limit switches what drawing will the mechanic
reference
Answer: Standardized detail drawing
●● Where should you place a lifeline when installing them
Answer: close enough to permit tying off prior to entering
●● millimeters to inches
Answer: divide by 25.4
●● Inches to millimeters
, Answer: multiply by 25.4
●● Drawings that are approved by the building owner or representative
are labeled with what term
Answer: Final
●● In a standard orthographic projection drawing, where is the
placement of a back view if needed
Answer: Off to one side of the working drawing
●● What is the most common drawing method for showing three sides
of an object at once in the elevator industry
Answer: Isometric Drawing
●● How would you describe a class 3 fit for shaft and bore diameters
Answer: Snuggest possible allowance
●● Which class of bolts provides the highest level of precision
Answer: Class 3 bolts
●● What is the difference between U.S standard and metric standard
threads?
REVIEW SHEET TESTED QUESTIONS AND
ANSWERS
●● How to turn Lbs to Kg
Answer: Divide by 2.2
●● Wheat types of detail drawings would you expect to see on a elevator
installation job
Answer: Standardized, electrical, structural and hoistway drawings
●● Installing hoistway limit switches what drawing will the mechanic
reference
Answer: Standardized detail drawing
●● Where should you place a lifeline when installing them
Answer: close enough to permit tying off prior to entering
●● millimeters to inches
Answer: divide by 25.4
●● Inches to millimeters
, Answer: multiply by 25.4
●● Drawings that are approved by the building owner or representative
are labeled with what term
Answer: Final
●● In a standard orthographic projection drawing, where is the
placement of a back view if needed
Answer: Off to one side of the working drawing
●● What is the most common drawing method for showing three sides
of an object at once in the elevator industry
Answer: Isometric Drawing
●● How would you describe a class 3 fit for shaft and bore diameters
Answer: Snuggest possible allowance
●● Which class of bolts provides the highest level of precision
Answer: Class 3 bolts
●● What is the difference between U.S standard and metric standard
threads?
