CM 3111 TEST 2 QUESTIONS AND ACCURATE
ANSWERS
The unit of measure that is used for wood decking is _____________. This is
determined by calculating the square feet of area to be covered and multiplying it by a
thickness of wood factor.
A. Board measure
B. Number of sheets required
C. Decking volume
D. Linear feet required - answers - board measure
What unit of measure is most likely to be used for laminated beams?
A. Linear inches
B. The beam measure
C. Linear feet
D. Number of beams - answers - linear feet
Both aluminum and steel are sold by ____________, so takeoff is made in
____________ and converted into ____________.
A. Length, feet, yards
B. Weight, pounds, tons
C. Length, yards, feet
D. Weight, tons, pounds - answers - weight, pounds, tons
__________ is the rise of the roof divided by the span
A. Pitch
B. Joist
C. Slope
D. Rafter length - answers - pitch
How do you determine the number of joists (floor and ceiling) required?
A. Divide the spacing of the joist into the length to be covered and subtract one
B. From the contract documents determined the size, spacing, and grade of framing
required
C. Calculate the width of the joists, remember to exclude bearing at the end and don't
lap
D. All of the above - answers - from the contract documents determine the size,
spacing, and grade of framing required
_____________ lumber is wood that has been sawed, edged, and trimmed, but has not
been dressed.
A. Rough
B. Dressed
ANSWERS
The unit of measure that is used for wood decking is _____________. This is
determined by calculating the square feet of area to be covered and multiplying it by a
thickness of wood factor.
A. Board measure
B. Number of sheets required
C. Decking volume
D. Linear feet required - answers - board measure
What unit of measure is most likely to be used for laminated beams?
A. Linear inches
B. The beam measure
C. Linear feet
D. Number of beams - answers - linear feet
Both aluminum and steel are sold by ____________, so takeoff is made in
____________ and converted into ____________.
A. Length, feet, yards
B. Weight, pounds, tons
C. Length, yards, feet
D. Weight, tons, pounds - answers - weight, pounds, tons
__________ is the rise of the roof divided by the span
A. Pitch
B. Joist
C. Slope
D. Rafter length - answers - pitch
How do you determine the number of joists (floor and ceiling) required?
A. Divide the spacing of the joist into the length to be covered and subtract one
B. From the contract documents determined the size, spacing, and grade of framing
required
C. Calculate the width of the joists, remember to exclude bearing at the end and don't
lap
D. All of the above - answers - from the contract documents determine the size,
spacing, and grade of framing required
_____________ lumber is wood that has been sawed, edged, and trimmed, but has not
been dressed.
A. Rough
B. Dressed
