RECENT EXAM 2026|2027 ACTUAL COMPLETE REAL
EXAM QUESTIONS AND CORRECTLY WELL DEFINED
ANSWERS (VERIFIED ANSWERS) ALREADY
GRADED A+ GUARANTEED SUCCESS!!!
NEWEST EXAM | JUST RELEASED!!
What buttons are on the ACP - ANSWER-MECH ground
personell
ATT attendants
CALL Selcall-
what do you use if a radio fails? - ANSWER-Audio switching
panel
ACARS - ANSWER-Aircraft Communications Addressing and
Reporting System
uses vhf 3 its for dispatch and tech ops
how do you access the ACARS - ANSWER-Access to ACARS is
accomplished through the Multi Function Control and Display
Unit (MCDU).
Intercom system - ANSWER-Aircraft inter-communications and
other cabin functions are controlled by two Cabin
Intercommunications Data System (CIDS) computers.
,Either CIDS computer is capable of performing all system
functions.
If both computers fail, you are informed by an ECAM message.
The CIDS computers control the following items:
PA system
Cabin lighting, normal and emergency
Cabin signs
CALLS system
Lavatory smoke indications
Flight, cabin, and service interphone systems
how many interphone systems are there? - ANSWER-3
The cabin interphone system enables communications
between the flight deck and the cabin.
The service interphone system provides the ability to
communicate between the flight deck and maintenance
receptacles located around the exterior of the aircraft.
The service interphone system also allows for communications
between all the receptacles to facilitate maintenance
operations.
The flight interphone system is controlled from the ACP.
How to turn off hot mike? - ANSWER-If a hot mic function is
not desired, the INT RAD switch should be centered. rad is held
down as a push to talk and if it is left up in the INT position it is
hot mike
, PA system can be accessed how? - ANSWER-Handsets located
at the forward and aft flight attendant stations are used to
make PAs from the cabin.
Pilots can make PA announcements from the flight deck using
the handset located at the rear of the pedestal.
This is accomplished by removing the handset from its holder
and pushing and holding the PTT pb on the handset.
Announcements can be monitored in your headset and flight
deck loudspeakers by selecting the PA reception knob.
When the transmission key is pressed and held, the key
currently selected on that ACP is deselected.
You are now transmitting on the PA system from your headset
boom microphone or oxygen mask microphone.
Calls System - ANSWER-CALLS system is used to signal the
need to communicate between:
Pilots
Flight Attendants
Ground crew
Pilots use the CALLS panel on the overhead panel
Flight attendants use handsets at the forward and aft flight
attendant stations
The ground crew uses the external power panel
What does the EMER PB do on the calls panel? - ANSWER-If a
need arises to urgently contact the lead flight attendant, the
EMER pb should be used.