TKA 2.0 Study Guide
_____ and _____ may be differentiated within 'healthcare professional options' regarding the
affected person's coronal deformity
a. Planning notifications, 'tensioning' extension pose capturable range
b. Workflow, initial assessment seize technique
c. Workflow, making plans notifications
d. Extension poses, and flexion poses - ANS-A. Planning notifications, 'tensioning/ extension
pose capturable range
'constitutional landmarks' are used to calculate the patient's _____
a. Corrected deformity
b. Native deformity
c. Constitutional alignment
d. Mechanical alignment - ANS-Constitutional alignment
'delta laxity' enabled presentations laxity values relative to the mounted '0-fee'; the software
constantly monitors for a brand new '0' price; consequently, the quantity displayed _____
a. Will in no way be below 0
b. Will constantly be above zero
c. Should always be 0
d. Is relative to the implant plan - ANS-A. Will in no way be under zero
1. If the implant plan is about for a length 3 femur and a size 2 tibia, what is the most quantity of
flexion that may be positioned at the femoral issue if the posterior slope is about to 3 without
soliciting a 'mixed flexion' warning
a. Five
b. Four
c. 10
d. 7 - ANS-A. 5
1. Within the 'trialing' web page, 'delta laxity' disabled presentations laxity values _____
a. Relative to the implant plan
b. Relative to real bone resections
c. Relative to articulating points of the trials
d. Relative to the '0-fee' hooked up via variety of motion - ANS-A. Relative to the implant plan
A 'capacity notch' may be brought about if _____
,a. No mentioned solution selections
b. The femur segmentation does not consist of enough of the shaft of the femur
c. Both cited solution choices
d. Anterior reduce is <5 from bone - ANS-D. Anterior cut is <5 from bone
A half bar represents ___ of laxity. - ANS-.5mm
A tilt icon will show if the limb's rotation closer to or far from the robotic exceed 5 even as the
limb is in flexion; this caution is only relevant in tensioning during the flexion pose _____
a. The tibial array might be bumped throughout bone education
b. Due to the weight of the limb impacting ligament tension, this will be witnessed whilst using a
force-input tensioning device
c. No referred to solution picks
d. Because the mako system is parked near the affected person - ANS-B. Due to the weight of
the limb impacting ligament anxiety, this may be witnessed at the same time as using a
pressure-enter tensioning device
Consider the subsequent state of affairs the femoral factor placement has brought on the
'proper notching' caution. Which of the following options is NOT a potential answer
a. No noted solution alternatives
b. Reduce the flexion of the femoral component
c. All stated answer choices
d. Upsize the femoral factor
e. Increase the flexion of the femoral component - ANS-B. Reduce the flexion of the femoral
aspect
Consider the following situation: the femoral aspect is oversized for the affected person. Which
of the subsequent warnings will maximum in all likelihood notify the user of this trouble
a. Implant proud of cut
b. True notch
c. Potential notch
d. Flange tip - ANS-D. Flange Tip
Consider the following scenario: The consumer cuts the distal femur and temporarily loses
energy to the MICS. What ought to have triggered the loss of strength? (distal femur with speed
error)
a. Velocity lure, one of the required trackers for the cutting-edge resection, moved beyond the
allowed restrict
b. Velocity trap, the fine metric for the saw final on the cutting aircraft is no longer met
c. Saw off-plane, the best metric for the noticed being on the reducing aircraft is now not met
, d. Saw off-plane, one of the required trackers for the modern resection moved past the allowed
limit - ANS-Velocity entice, one of the required trackers for the contemporary resection, moved
past the allowed limit
Consider the following situation: The user is capturing 'hip center' and the following mistakes
popped up and the person selected 'maintain' and decided to move forward with captured
landmarks. Which of the following statement(s) follow?
A. A caution may be displayed within the 'bone registration' tab
b. No noted answer alternatives
c. Both referred to solution choices
d. The femoral array has been bumped - ANS-A. A caution might be displayed in the 'bone
registration' tab
Consider the subsequent situation: The person is taking pictures the tibia affected person
landmarks and the following blunders pops up. "collected ankle with does not compare properly
with the CT. Take into account malleoli factors." How will the software program reply?
A. The captured tibia patient landmarks remain until the consumer deletes the landmark
b. The captured tibia affected person landmarks can be deleted, and the person might be
brought on to re-seize
c. No noted answer choices
d. 'hip center', 'medial malleolus' and 'lateral malleolus' could be deleted, and the person can be
brought on to recapture affected person landmarks - ANS-B. The captured tibia patient
landmarks may be deleted, and the user can be precipitated to re-capture
Consider the subsequent situation: the user is on the trialing web page capturing the extension
medial laxity pose. (Medial max is presently 10.Five and stay is 2mm) When the consumer
presses the '0' button how will the utility reply?
A. All values on the display will reset to 0mm
b. The extension medial max price will lower to 2mm, the extension medial stay laxity will lower
to 0mm
c. The pose might be deleted
d. No mentioned answer alternatives
e. The extension medial max price will decrease to 8.5mm; the extension medial stay laxity price
will lower to 0mm - ANS-E. The extension medial max value will decrease to eight.5mm; the
extension medial stay laxity value will lower to 0mm
Consider the subsequent situation: The person is on the Trialing page shooting the Extension
Medial Laxity pose. The medical professional confirmed all important trials are in the joint, and
the femoral trial is nicely articulating at the tibial insert. What must the user do next?
A. Press the 'zero' button
_____ and _____ may be differentiated within 'healthcare professional options' regarding the
affected person's coronal deformity
a. Planning notifications, 'tensioning' extension pose capturable range
b. Workflow, initial assessment seize technique
c. Workflow, making plans notifications
d. Extension poses, and flexion poses - ANS-A. Planning notifications, 'tensioning/ extension
pose capturable range
'constitutional landmarks' are used to calculate the patient's _____
a. Corrected deformity
b. Native deformity
c. Constitutional alignment
d. Mechanical alignment - ANS-Constitutional alignment
'delta laxity' enabled presentations laxity values relative to the mounted '0-fee'; the software
constantly monitors for a brand new '0' price; consequently, the quantity displayed _____
a. Will in no way be below 0
b. Will constantly be above zero
c. Should always be 0
d. Is relative to the implant plan - ANS-A. Will in no way be under zero
1. If the implant plan is about for a length 3 femur and a size 2 tibia, what is the most quantity of
flexion that may be positioned at the femoral issue if the posterior slope is about to 3 without
soliciting a 'mixed flexion' warning
a. Five
b. Four
c. 10
d. 7 - ANS-A. 5
1. Within the 'trialing' web page, 'delta laxity' disabled presentations laxity values _____
a. Relative to the implant plan
b. Relative to real bone resections
c. Relative to articulating points of the trials
d. Relative to the '0-fee' hooked up via variety of motion - ANS-A. Relative to the implant plan
A 'capacity notch' may be brought about if _____
,a. No mentioned solution selections
b. The femur segmentation does not consist of enough of the shaft of the femur
c. Both cited solution choices
d. Anterior reduce is <5 from bone - ANS-D. Anterior cut is <5 from bone
A half bar represents ___ of laxity. - ANS-.5mm
A tilt icon will show if the limb's rotation closer to or far from the robotic exceed 5 even as the
limb is in flexion; this caution is only relevant in tensioning during the flexion pose _____
a. The tibial array might be bumped throughout bone education
b. Due to the weight of the limb impacting ligament tension, this will be witnessed whilst using a
force-input tensioning device
c. No referred to solution picks
d. Because the mako system is parked near the affected person - ANS-B. Due to the weight of
the limb impacting ligament anxiety, this may be witnessed at the same time as using a
pressure-enter tensioning device
Consider the subsequent state of affairs the femoral factor placement has brought on the
'proper notching' caution. Which of the following options is NOT a potential answer
a. No noted solution alternatives
b. Reduce the flexion of the femoral component
c. All stated answer choices
d. Upsize the femoral factor
e. Increase the flexion of the femoral component - ANS-B. Reduce the flexion of the femoral
aspect
Consider the following situation: the femoral aspect is oversized for the affected person. Which
of the subsequent warnings will maximum in all likelihood notify the user of this trouble
a. Implant proud of cut
b. True notch
c. Potential notch
d. Flange tip - ANS-D. Flange Tip
Consider the following scenario: The consumer cuts the distal femur and temporarily loses
energy to the MICS. What ought to have triggered the loss of strength? (distal femur with speed
error)
a. Velocity lure, one of the required trackers for the cutting-edge resection, moved beyond the
allowed restrict
b. Velocity trap, the fine metric for the saw final on the cutting aircraft is no longer met
c. Saw off-plane, the best metric for the noticed being on the reducing aircraft is now not met
, d. Saw off-plane, one of the required trackers for the modern resection moved past the allowed
limit - ANS-Velocity entice, one of the required trackers for the contemporary resection, moved
past the allowed limit
Consider the following situation: The user is capturing 'hip center' and the following mistakes
popped up and the person selected 'maintain' and decided to move forward with captured
landmarks. Which of the following statement(s) follow?
A. A caution may be displayed within the 'bone registration' tab
b. No noted answer alternatives
c. Both referred to solution choices
d. The femoral array has been bumped - ANS-A. A caution might be displayed in the 'bone
registration' tab
Consider the subsequent situation: The person is taking pictures the tibia affected person
landmarks and the following blunders pops up. "collected ankle with does not compare properly
with the CT. Take into account malleoli factors." How will the software program reply?
A. The captured tibia patient landmarks remain until the consumer deletes the landmark
b. The captured tibia affected person landmarks can be deleted, and the person might be
brought on to re-seize
c. No noted answer choices
d. 'hip center', 'medial malleolus' and 'lateral malleolus' could be deleted, and the person can be
brought on to recapture affected person landmarks - ANS-B. The captured tibia patient
landmarks may be deleted, and the user can be precipitated to re-capture
Consider the subsequent situation: the user is on the trialing web page capturing the extension
medial laxity pose. (Medial max is presently 10.Five and stay is 2mm) When the consumer
presses the '0' button how will the utility reply?
A. All values on the display will reset to 0mm
b. The extension medial max price will lower to 2mm, the extension medial stay laxity will lower
to 0mm
c. The pose might be deleted
d. No mentioned answer alternatives
e. The extension medial max price will decrease to 8.5mm; the extension medial stay laxity price
will lower to 0mm - ANS-E. The extension medial max value will decrease to eight.5mm; the
extension medial stay laxity value will lower to 0mm
Consider the subsequent situation: The person is on the Trialing page shooting the Extension
Medial Laxity pose. The medical professional confirmed all important trials are in the joint, and
the femoral trial is nicely articulating at the tibial insert. What must the user do next?
A. Press the 'zero' button
