IMSA SIGNAL TECHNICIAN LEVEL 1 | COMPLETE QUESTIONS
WITH 100% RATED EXPERT SOLUTIONS |2026 LATEST UPDATED
What is the primary function of the IMSA? - (answer)Safety education
IMSA stands for: - (answer)International Municipal Signal Association
Which of the following is NOT an IMSA certification? - (answer)Y: Traffic Signal Level II
Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - (answer)Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - (answer)Circular red, circular green
PPE stands for: - (answer)Personal Protective Equipment
, Which of the follow is an example of adequate fall protection during the operation of aerial lift
equipment? - (answer)Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - (answer)Ensure advance
warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - (answer)Y: Standards;
requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control
Signals: - (answer)Three-section traffic signal with circular red, circular yellow, and smaller
circular yellow indications
WITH 100% RATED EXPERT SOLUTIONS |2026 LATEST UPDATED
What is the primary function of the IMSA? - (answer)Safety education
IMSA stands for: - (answer)International Municipal Signal Association
Which of the following is NOT an IMSA certification? - (answer)Y: Traffic Signal Level II
Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards? - (answer)Overhead and underground power
Gas
Aerial lift equipment
What are the sections of a ramp meter signal? - (answer)Circular red, circular green
PPE stands for: - (answer)Personal Protective Equipment
, Which of the follow is an example of adequate fall protection during the operation of aerial lift
equipment? - (answer)Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks? - (answer)Ensure advance
warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD? - (answer)Y: Standards;
requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle Traffic Control
Signals: - (answer)Three-section traffic signal with circular red, circular yellow, and smaller
circular yellow indications
