CCIL LATEST EXAMS SCRIPTED ALL QUESTIONS
AND ANSWERS SURE A+
\
✔✔Movable Portion of Bearing Block - ✔✔Must be able to rotate freely and tilt 4
degrees in any direction.
✔✔Capping Recess/Mould - ✔✔Depth 5-12mm and shall be 10-25mm larger than
diameter of specimen. Metal plate thickness of recessed area should not be less than
12mm.
✔✔The surface of the recessed area of the capping mould should not depart from a
plane by... - ✔✔More than 0.05mm in 152mm.
✔✔Length of specimen with caps - ✔✔Measured to the nearest mm when length-to-
diameter ratio is less than 1.8 or more than 2.2 or when cylinder volume is to be
determined.
✔✔Planeness - ✔✔The ends of cylinders must not depart from a plane by more than
0.05mm.
✔✔Checking planeness of cylinders - ✔✔Every 10th cylinder, but no less than 3 in one
day.
AND ANSWERS SURE A+
\
✔✔Movable Portion of Bearing Block - ✔✔Must be able to rotate freely and tilt 4
degrees in any direction.
✔✔Capping Recess/Mould - ✔✔Depth 5-12mm and shall be 10-25mm larger than
diameter of specimen. Metal plate thickness of recessed area should not be less than
12mm.
✔✔The surface of the recessed area of the capping mould should not depart from a
plane by... - ✔✔More than 0.05mm in 152mm.
✔✔Length of specimen with caps - ✔✔Measured to the nearest mm when length-to-
diameter ratio is less than 1.8 or more than 2.2 or when cylinder volume is to be
determined.
✔✔Planeness - ✔✔The ends of cylinders must not depart from a plane by more than
0.05mm.
✔✔Checking planeness of cylinders - ✔✔Every 10th cylinder, but no less than 3 in one
day.
