ARGUS 2026 OPERATIONAL SAFETY
EVALUATION AND REPORTING REVIEW
QUESTIONS SOLUTIONS PROFESSIONAL
GUIDE
◉ All entries that begin with a "relative" start date will be relative to
which date?
Answer: Analysis Start Date
◉ Reporting Start Date
Answer: - Sets the date at which reports will begin
- Does not alter the timing of base calculations in the program
◉ Reporting Start Date must fall (where) relative to the Analysis
Start Date
Answer: on or after the Analysis Start Date
◉ Analysis of up to (xx) years may be conducted
Answer: 40
◉ If the analysis begins midyear...
, Answer: ARGUS will calculate a stub year with the partial year in the
first year
◉ Default unit of Area Measures is?
Answer: Square Feet
◉ When entering a inflation percentage that is less than 1%, it must
be in what form?
Answer: decimal
◉ Percentages of inflation may be entered as...
Answer: positive or negative whole numbers, or a decimal
◉ If an inflation field is left empty...
Answer: it will default to the General Inflation Rate
◉ Why is inflation in year 1 never available?
Answer: Because it does not occur until the beginning of the 2nd
year
◉ Inflation input into Year 2 will apply to which years numbers?
Answer: Year 1
EVALUATION AND REPORTING REVIEW
QUESTIONS SOLUTIONS PROFESSIONAL
GUIDE
◉ All entries that begin with a "relative" start date will be relative to
which date?
Answer: Analysis Start Date
◉ Reporting Start Date
Answer: - Sets the date at which reports will begin
- Does not alter the timing of base calculations in the program
◉ Reporting Start Date must fall (where) relative to the Analysis
Start Date
Answer: on or after the Analysis Start Date
◉ Analysis of up to (xx) years may be conducted
Answer: 40
◉ If the analysis begins midyear...
, Answer: ARGUS will calculate a stub year with the partial year in the
first year
◉ Default unit of Area Measures is?
Answer: Square Feet
◉ When entering a inflation percentage that is less than 1%, it must
be in what form?
Answer: decimal
◉ Percentages of inflation may be entered as...
Answer: positive or negative whole numbers, or a decimal
◉ If an inflation field is left empty...
Answer: it will default to the General Inflation Rate
◉ Why is inflation in year 1 never available?
Answer: Because it does not occur until the beginning of the 2nd
year
◉ Inflation input into Year 2 will apply to which years numbers?
Answer: Year 1