Michigan State Brakes Certification Exam | Questions with
100% Correct Answers | Verified | Latest Update 2026/2027
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Ch. 87 Onboard Diagnosis Phase II Air Assault M240 machine gun Ae
Teacher 32 terms Teacher 163 terms Teacher 28 terms Te
maxwelltonny56 Preview kyalomumo195 Preview feskioko2012 Preview
Terms in this set (35)
Most 1995 & newer vehicles use which of the following Sealed non-serviceable
types of wheels bearings on non-drive wheel?
to test a vacuum power brake booster in the vehicle, drop slightly and remain firm
you should pump the brake pedal at least 4 times, hold
the brake pedal depressed, and start the engine. the
brake pedal should:
You are installing a set of brake shoe linings that are not Smaller and goes towards the front of the car.
the same length. Traditionally, the primary shoe lining is:
A cracked or torn vacuum diaphragm in a brake power a hard pedal feel requiring very high pedal effort to stop
booster would most likely cause:
Which of the following incorrect service procedures master cylinder push rod adjusted too long
will cause brake lock-up?
Which of the following describes the proper way to Pump the brake pedal at least 25 times (or more, depending on the
depressurized an ABS system? manufacturer's recommendation) with the ignition off.
100% Correct Answers | Verified | Latest Update 2026/2027
Leave the first rating
Save
Students also studied
Flashcard sets Study guides
Ch. 87 Onboard Diagnosis Phase II Air Assault M240 machine gun Ae
Teacher 32 terms Teacher 163 terms Teacher 28 terms Te
maxwelltonny56 Preview kyalomumo195 Preview feskioko2012 Preview
Terms in this set (35)
Most 1995 & newer vehicles use which of the following Sealed non-serviceable
types of wheels bearings on non-drive wheel?
to test a vacuum power brake booster in the vehicle, drop slightly and remain firm
you should pump the brake pedal at least 4 times, hold
the brake pedal depressed, and start the engine. the
brake pedal should:
You are installing a set of brake shoe linings that are not Smaller and goes towards the front of the car.
the same length. Traditionally, the primary shoe lining is:
A cracked or torn vacuum diaphragm in a brake power a hard pedal feel requiring very high pedal effort to stop
booster would most likely cause:
Which of the following incorrect service procedures master cylinder push rod adjusted too long
will cause brake lock-up?
Which of the following describes the proper way to Pump the brake pedal at least 25 times (or more, depending on the
depressurized an ABS system? manufacturer's recommendation) with the ignition off.
