FLORIDA ELECTRICAL EXAM 2 LATEST
2026/2027 WITH 100 REAL QUESTIONS AND
EXPERT-VERIFIED CORRECT ANSWERS |
ALREADY GRADED A+ | GUARANTEED
PASS | FLORIDA ELECTRICAL EXAM [NEW
VERSION]
Which of the following is a solution for when the sign structure prevents the main
sign support from being directly attached to the sign cabinet?
A. The truss members must be reinforced to carry load
B. Cantilever arms and torsion beams must carry structural loads from the sign
cabinet to the main supports
C. A support socket should be fabricated
D. None of the above
B. Cantilever arms and torsion beams must carry structural loads from the sign
cabinet to the main supports
Where required, conduit seals installed in Class I, Division 1 & 2 locations shall
have the minimum thickness of the sealing compound not less than the trade size
of the sealing fitting and, in no case less than _____ inch.
,A. 1/2
B. 5/8
C. 3/4
D. 1
B. 5/8
To positive a gas discharge electrons must be removed from neutral molecules and
recombined with positive ions to form other neutral molecules. The practical way
of producing this ionization is by _____.
A. Passing a current through the gas
B. Using an electron neutralizer
C. Connecting the tube to an ionizer
D. None of the above
A. Passing a current through the gas
The ampacity requirements for a disconnecting means of x-ray equipment shall be
based on at LEAST ____ percent of the input required for the momentary rating of
the equipment, if greater than the long-term rating.
A. 125
B. 115
C. 80
D. 50
D. 50
,Portable structures for fairs, carnivals and similar events shall not be located under
or within _____ feet horizontally of conductors operating in excess of 600 volts.
A. 22 1/2
B. 15
C. 10
D. 12
B. 15
A ________ is placed below the water surface, and concrete is gently and
continuously laid in even layer.
A. Concrete mixer
B. Tremie
C. Concrete pump hose
D. Grout pump hose
B. Tremie
Enclosures containing circuit breakers, switches and motor controllers located in
Class II, Division 2 locations, shall be ____ or otherwise identified for the location.
A. Gastight
, B. Vapor-proof
C. Dusttight
D. Stainless steel
C. Dusttight
Electrical services and feeder for recreational vehicle parks shall be calculated on
the basis of NOT less than _____ volt-amperes per RV site equipped with both 20-
ampere supply facilities.
A. 9600
B. 4800
C. 3600
D. 2400
C. 3600
Where located in Class I, Division 1 locations, transformer containing oil or a
liquid that will burn shall be _____.
A. Enclosed in a fence
B. Installed in vaults only
C. Identified for use in Class I locations
D. Installed in fire-resistant room
B. Installed in vaults only
2026/2027 WITH 100 REAL QUESTIONS AND
EXPERT-VERIFIED CORRECT ANSWERS |
ALREADY GRADED A+ | GUARANTEED
PASS | FLORIDA ELECTRICAL EXAM [NEW
VERSION]
Which of the following is a solution for when the sign structure prevents the main
sign support from being directly attached to the sign cabinet?
A. The truss members must be reinforced to carry load
B. Cantilever arms and torsion beams must carry structural loads from the sign
cabinet to the main supports
C. A support socket should be fabricated
D. None of the above
B. Cantilever arms and torsion beams must carry structural loads from the sign
cabinet to the main supports
Where required, conduit seals installed in Class I, Division 1 & 2 locations shall
have the minimum thickness of the sealing compound not less than the trade size
of the sealing fitting and, in no case less than _____ inch.
,A. 1/2
B. 5/8
C. 3/4
D. 1
B. 5/8
To positive a gas discharge electrons must be removed from neutral molecules and
recombined with positive ions to form other neutral molecules. The practical way
of producing this ionization is by _____.
A. Passing a current through the gas
B. Using an electron neutralizer
C. Connecting the tube to an ionizer
D. None of the above
A. Passing a current through the gas
The ampacity requirements for a disconnecting means of x-ray equipment shall be
based on at LEAST ____ percent of the input required for the momentary rating of
the equipment, if greater than the long-term rating.
A. 125
B. 115
C. 80
D. 50
D. 50
,Portable structures for fairs, carnivals and similar events shall not be located under
or within _____ feet horizontally of conductors operating in excess of 600 volts.
A. 22 1/2
B. 15
C. 10
D. 12
B. 15
A ________ is placed below the water surface, and concrete is gently and
continuously laid in even layer.
A. Concrete mixer
B. Tremie
C. Concrete pump hose
D. Grout pump hose
B. Tremie
Enclosures containing circuit breakers, switches and motor controllers located in
Class II, Division 2 locations, shall be ____ or otherwise identified for the location.
A. Gastight
, B. Vapor-proof
C. Dusttight
D. Stainless steel
C. Dusttight
Electrical services and feeder for recreational vehicle parks shall be calculated on
the basis of NOT less than _____ volt-amperes per RV site equipped with both 20-
ampere supply facilities.
A. 9600
B. 4800
C. 3600
D. 2400
C. 3600
Where located in Class I, Division 1 locations, transformer containing oil or a
liquid that will burn shall be _____.
A. Enclosed in a fence
B. Installed in vaults only
C. Identified for use in Class I locations
D. Installed in fire-resistant room
B. Installed in vaults only
