SACA C-215 Robotic Systems EXAM STUDY GUIDE 2026/2027 ACCURATE QUESTIONS WITH CORRECT DETAILED SOLUTIONS || 100% GUARANTEED PASS NEWEST VERSION

SACA C-215 Robotic Systems EXAM STUDY GUIDE 2026/2027 ACCURATE QUESTIONS WITH CORRECT DETAILED SOLUTIONS || 100% GUARANTEED PASS NEWEST VERSION 1. Which type of robot griper can adjust Its finger position based on feedback? A. Pnumatic 2-point B. Pnumatic 3-point C. Hydraulic D. Electro Servo - ANSWER D. Electro Servo 2. When a robot is in automatic cycle, what function is active on the teach pendant? A. Teaching points B. Downloading programs C. Editing programs D. Selecting programs - ANSWER D. Selecting programs 3. How would you verify that the axis position information shown on a teach pendent is accurate while in joint jog mode? A. Perform axis calibration procedure with teach pendant B. Set up a work cell zero reference point C. Compare axis position when robot axes are aligned with calibration marks D. Master the robot - ANSWER C. Compare axis position when robot axes are aligned with calibration marks 4. what type of robot is shown (different image)? A. Gantry B. SCARA C. Articulated D. Non-servo - ANSWER B. SCARA 5. Which of these can affect the range of a robot's work envelope? A. Axis motor size B. Machine guard/Safety fence C. Program D. End of arm tooling - ANSWER B. Machine guard/Safety fence 6. What action takes place when a robot's emergency stop pushbutton is pressed while a robot is performing its automatic cycle? A. Robot motion is halted by disconnecting main power. B. Robot immediately stops cycle and resets to safe position C. Robot is halted through dynamic braking and mechanical brakes engaged D. Robot program pauses motion and waits for operator to press a button on the teach pendant to continue program - ANSWER C. Robot is halted through dynamic braking and mechanical brakes engaged 7. What type of safety device would you use for a robot work cell that must automatically pass parts out of the work cell after they are produced? A. Light curtain B. Personnel door C. Safety fence D. Safety mats - ANSWER C. Safety fence 8. What robot is affected when using a robot in test mode? A. Emergency stop B. Axis software limits C. Jog speed D. Lighting - ANSWER C. Jog speed 9. What robot position programming frame would be best used to minimize program changes if the workpiece moves to a different location? A. World B. Tool C. User D. Jog - ANSWER C. User 10. What are the cartesian coordinates of point 1 shown? Each mark on scale represents 10mm. (no image) A. -20,30,40 B. 30,40,-20 C.20,30,40 D. 30,-20,40 - ANSWER D. 30,-20,40 11. What indication would signal the operator that someone has triggered a pressure sensitive safety mat on a robot work cell? A. All indicator lights on work cell turn off B. Controller fault light turns on C. Teach pendant alarm sounds D. Robot resets to safe position - ANSWER B. Controller fault light turns on 12. Where would you likely find the model number and serial number of a robot? A. Teach pendent screen B. Tag affixed to end effector C. Tag affixed to robot base D. Robot controller firmware - ANSWER C. Tag affixed to robot base