1.22.23) QUESTIONS WITH ACCURATE ANSWERS
______________________ is used to classify a refrigerant according to the
potential hazards involved with its use, specifically toxicity and flammability
correct answer ASHRAE Standard 34
2L refrigerants have a burning velocity of ____________________________ or
less, making them less likely to sustain combustion after the initial ignition source
has been removed. correct answer 10 cm/s (3.9 inches per second)
A complex process that cleans, filters, and tests a refrigerant to meet the "like-
new" purity level specified in AHRI Standard 700 is; correct answer reclamation
A metric that is used to measure a refrigerant's environmental impact as a
greenhouse gas is; correct answer Global Warming Potential (GWP)
A refrigerant blend behaves like a single compound refrigerant is called a(n);
correct answer azeotropic blend
A refrigerant oil that is hygroscopic will; correct answer absorb moisture
A2L refrigerants have a flammability potential that is higher than; correct answer
A1 refrigerants
Always keep a Class ______, ______-powder, fire extinguisher on the jobsite and
use a refrigerant monitor during installation or service. correct answer Class B,
dry-powder
, Burning velocity correct answer the rate at which a flame front spreads relative to
the unburned gas ahead of the flame.
Class 2L refrigerants have a much ______ heat of combustion than A3
refrigerants. correct answer lower
Department of Transportation (DOT) standards require that a recovery tank
should not be fill beyond what percent of its capacity? correct answer 80%
DOT regulations require refrigerant cylinders containing over _____________ of a
2L refrigerant to be equipped with a pressure relief valve instead of a rupture
disc. correct answer 2.2 lbs.
DOT rules prohibit smoking within how many feet of a cylinder containing a
flammable gas? correct answer 25 feet
EPA Section 608 regulations require that if a system is charged with a flammable
refrigerant, the equipment must have? correct answer red, Pantone® Matching
System (PMS) markings on the service and access valves.
For most residential and light commercial heat pump and air conditioning systems
containing less than 200 pounds of either R-22 or R-410A, the required recovery
level is; correct answer 0 psig
HC refrigerants contain hydrogen and carbon and are classified by ASHRAE in the
A3 safety group. Due to their highly flammable nature, their use is limited to