NASCLA Electrical Exam (2026) || Most Recent Exam
2026-2027Actual Complete Real Exam Questions
And Correct Answers (Expertly Verified Answers)
Already Graded A+ | Guaranteed Success!! |
Brand New Exam!! Just Released!!
When two or more single phase dryers are supplied by a 3-
phase 4-wire feeder or service, the total load shall be calculated
on the basis of ____________ the maximum number connected
between any two phases. - ANSWER-twice
It shall be permissible to calculate the load for commercial
electric cooking equipment, dishwasher booster heaters, water
heaters, and other kitchen equipment in accordance with table
220.56. The demand factor for these units is ___________
percent for the first two devices, and ____________ percent for
the third and _________ percent for the fourth. - ANSWER-100,
90, 80
Kitchen equipment demand factors shall not apply for
___________,
____________, and _______________ equipment - ANSWER-
Space heating, ventilating, or air conditioning. (continuous)
Optional load calculations for
dwellings allow for:
, 100% of the first 10kva plus 40% of the remainder of the
following loads:
_________ VA per square foot for general lighting and
receptacles _________ VA for each 2-wire 20-A small
appliance branch circuit and each laundry branch circuit
_________ VA for all appliances fastened in place permanently
connected, or located on a specific circuit.
_________ VA for all motors
Add this with the heating and Air conditioning load
- ANSWER-3
1500
Name
Plate
Name
Plate
The optional method of calculation for dwelling units is
reserved for – ANSWER-dwelling units supplied by service
conductors with an ampacity of 100 amperes or greater.
When calculating the service-entrance conductors of a farm
where all the buildings, including the dwelling, are supplied
from a common service, the second largest individual load in
the group shall be calculated at _____. -
ANSWER-75%
2026-2027Actual Complete Real Exam Questions
And Correct Answers (Expertly Verified Answers)
Already Graded A+ | Guaranteed Success!! |
Brand New Exam!! Just Released!!
When two or more single phase dryers are supplied by a 3-
phase 4-wire feeder or service, the total load shall be calculated
on the basis of ____________ the maximum number connected
between any two phases. - ANSWER-twice
It shall be permissible to calculate the load for commercial
electric cooking equipment, dishwasher booster heaters, water
heaters, and other kitchen equipment in accordance with table
220.56. The demand factor for these units is ___________
percent for the first two devices, and ____________ percent for
the third and _________ percent for the fourth. - ANSWER-100,
90, 80
Kitchen equipment demand factors shall not apply for
___________,
____________, and _______________ equipment - ANSWER-
Space heating, ventilating, or air conditioning. (continuous)
Optional load calculations for
dwellings allow for:
, 100% of the first 10kva plus 40% of the remainder of the
following loads:
_________ VA per square foot for general lighting and
receptacles _________ VA for each 2-wire 20-A small
appliance branch circuit and each laundry branch circuit
_________ VA for all appliances fastened in place permanently
connected, or located on a specific circuit.
_________ VA for all motors
Add this with the heating and Air conditioning load
- ANSWER-3
1500
Name
Plate
Name
Plate
The optional method of calculation for dwelling units is
reserved for – ANSWER-dwelling units supplied by service
conductors with an ampacity of 100 amperes or greater.
When calculating the service-entrance conductors of a farm
where all the buildings, including the dwelling, are supplied
from a common service, the second largest individual load in
the group shall be calculated at _____. -
ANSWER-75%
