Page |1
vehicle communication system Questions with Verified
Answers UPDATED!!!
what is the resistance of the terminating resistor on networks
equipped with one start connector? - ANSWER 60 ohms
with the bus active and no faults present, what voltages should
be measured on CAN-C(+)? - ANSWER approximately 3.2v
what Atlantis-high network uses splice block connectors? -
ANSWER CAN-BH
with the bus active and no faults present, what voltages should
be measured on CAN-B(-)? - ANSWER approximately 0.4v
which resource should be used first for troubleshooting DRB III
Emulator concerns? - ANSWER wiTECH knowledge base
with the bus active and no faults present, what voltages should
be measured on LIN? - ANSWER 7.0v-10.0v
vehicle communication system Questions with Verified
Answers UPDATED!!!
what is the resistance of the terminating resistor on networks
equipped with one start connector? - ANSWER 60 ohms
with the bus active and no faults present, what voltages should
be measured on CAN-C(+)? - ANSWER approximately 3.2v
what Atlantis-high network uses splice block connectors? -
ANSWER CAN-BH
with the bus active and no faults present, what voltages should
be measured on CAN-B(-)? - ANSWER approximately 0.4v
which resource should be used first for troubleshooting DRB III
Emulator concerns? - ANSWER wiTECH knowledge base
with the bus active and no faults present, what voltages should
be measured on LIN? - ANSWER 7.0v-10.0v