one - correct_answNo more than ____ load should be placed in any
circuit line between L1and L2.
parallel - correct_answLoads must be connected in _____ when more
than one load must be connected in the line diagram.
series,parallel - correct_answTwo control devices can be connected in
____ or ____ to control a coil in a magnetic motor starter.
pilot lights - correct_answ_____ signal an operator that any one of a
sequence of events may be taking place.
simple - correct_answThe dashed line method works well when the
control contacts are close together and the circuit is relatively ____.
Complex - correct_answThe numerical cross-reference method is used
on ____ line diagrams.
circuit line between L1and L2.
parallel - correct_answLoads must be connected in _____ when more
than one load must be connected in the line diagram.
series,parallel - correct_answTwo control devices can be connected in
____ or ____ to control a coil in a magnetic motor starter.
pilot lights - correct_answ_____ signal an operator that any one of a
sequence of events may be taking place.
simple - correct_answThe dashed line method works well when the
control contacts are close together and the circuit is relatively ____.
Complex - correct_answThe numerical cross-reference method is used
on ____ line diagrams.
