Page |1
Aci epoxy anchors Questions and Correct
Answers/ Latest Update / Already Graded
As specified concrete temperature can vary from ? in this ESR, anchors
shall not be used for applications where the in-service or less to ? or
higher within a 12-hour period.
Ans: 40°F (5°C), 80°F (27°C)
According to ESR-2583, the peak temperature of the concrete in which
an anchor can be installed is:
Ans: 104 F (40 C)
Percentages of anchors to be proof-loaded are:
Ans: D. Specified in the contract documents
Proof loading is applied as confined tension tests and shall not exceed:
Ans: 50% expected peak load based on adhesive bond strength
or 80% of the anchor yield strength
According to ESR-2583, storage of the adhesive product prior to and
during use shall be
All rights reserved © 2025/ 2026 |
, Page |2
Ans: In a cool, dry, and well-ventilated area
Prior to installation, the inspector must check the anchor elements for:
Ans: Substances that may affect bond and thread damage
According to ESR-2583, the minimum brush diameter for hole cleaning
when installing a 3/4-in diameter anchor is:
Ans: 0.920 inches on the instructions mpii
According to ESR-2583, the maximum allowed temperature of the
cartridge during use is:
Ans: 95°F
Anchors qualified by ACI 355.4-1l are always qualified for use in:
Ans: Low and high strength concrete
Adhesive anchors installed horizontally or upwardly inclined shall be
qualified in accordance with:
Ans: ACI 355.4
All rights reserved © 2025/ 2026 |
Aci epoxy anchors Questions and Correct
Answers/ Latest Update / Already Graded
As specified concrete temperature can vary from ? in this ESR, anchors
shall not be used for applications where the in-service or less to ? or
higher within a 12-hour period.
Ans: 40°F (5°C), 80°F (27°C)
According to ESR-2583, the peak temperature of the concrete in which
an anchor can be installed is:
Ans: 104 F (40 C)
Percentages of anchors to be proof-loaded are:
Ans: D. Specified in the contract documents
Proof loading is applied as confined tension tests and shall not exceed:
Ans: 50% expected peak load based on adhesive bond strength
or 80% of the anchor yield strength
According to ESR-2583, storage of the adhesive product prior to and
during use shall be
All rights reserved © 2025/ 2026 |
, Page |2
Ans: In a cool, dry, and well-ventilated area
Prior to installation, the inspector must check the anchor elements for:
Ans: Substances that may affect bond and thread damage
According to ESR-2583, the minimum brush diameter for hole cleaning
when installing a 3/4-in diameter anchor is:
Ans: 0.920 inches on the instructions mpii
According to ESR-2583, the maximum allowed temperature of the
cartridge during use is:
Ans: 95°F
Anchors qualified by ACI 355.4-1l are always qualified for use in:
Ans: Low and high strength concrete
Adhesive anchors installed horizontally or upwardly inclined shall be
qualified in accordance with:
Ans: ACI 355.4
All rights reserved © 2025/ 2026 |
