IMSA Signal Technician Level 1 End of
Chapter Questions and Answers| Updated
What is the primary function of the IMSA?
Safety education
IMSA stands for:
International Municipal Signal Association
Which of the following is NOT an IMSA certification?
Y: Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards?
Overhead and underground power
Gas
,Aerial lift equipment
What are the sections of a ramp meter signal?
Circular red, circular green
PPE stands for:
Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the
operation of aerial lift equipment?
Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks?
Ensure advance warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD?
, Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good
reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle
Traffic Control Signals:
Three-section traffic signal with circular red, circular yellow, and smaller circular
yellow indications
The following phases are typically assigned to the major street through
movements:
2 and 6
The green interval is made up which three components?
Minimum green, passage time, maximum green
What are the three types of recall features of a traffic signal controller?
Minimum, maximum, pedestrian (+soft)
Chapter Questions and Answers| Updated
What is the primary function of the IMSA?
Safety education
IMSA stands for:
International Municipal Signal Association
Which of the following is NOT an IMSA certification?
Y: Traffic Signal Level II Design/Engineer Technician
Y: Traffic Signal Level II Field Technician
Y: Traffic Signal Level II Bench Technician
N: Traffic Signal Level III Bridge Design Technician
Which of the following are potential safety hazards?
Overhead and underground power
Gas
,Aerial lift equipment
What are the sections of a ramp meter signal?
Circular red, circular green
PPE stands for:
Personal Protective Equipment
Which of the follow is an example of adequate fall protection during the
operation of aerial lift equipment?
Full body harness
Safety belt
Rails of a platform lift
Work Zone Supervisor is responsible for which of the following tasks?
Ensure advance warning devices have not been removed or relocated
Which of the following is NOT a sentence type in the MUTCD?
, Y: Standards; requirements that have to be followed
Y: Guidance; recommendations that are to be followed unless there is a good
reason not to
N: Objectives; reasons behind the standards and guidance
y: Support; additional information to clarify the standards and guidance
Which of the following is an example configuration of an Emergency-Vehicle
Traffic Control Signals:
Three-section traffic signal with circular red, circular yellow, and smaller circular
yellow indications
The following phases are typically assigned to the major street through
movements:
2 and 6
The green interval is made up which three components?
Minimum green, passage time, maximum green
What are the three types of recall features of a traffic signal controller?
Minimum, maximum, pedestrian (+soft)
