NCCER Module 4 Intro to power tools Exam
Questions and Verified Answers
100% Guarantee Pass
1. A saw that has a thin one-piece blade that runs around guides, that runs
around either end of the saw is a
Answer: Band saw
2. A power miter saw combines a miter box with a
Answer: Circular saw
3. An angle grinder is used to grind
Answer: Hard heavy materials
4. The adjustable tool rest on a bench grinder should be positioned
Answer: One eighth of an inch from the grinding tool
5. A good way to check the condition of the grinding wheel on a bench grinder is
to
Answer: Perform a ring test
6. A grinder can catch on rough material edges and shift around, especially
, when using rotary bits called
Answer: Burr bits
7. When using power tools never engage the
Answer: Trigger locks
8. Before replacing parts such as bits, blades, or discs on any tool, you must
Answer: -
Disconnect the power source
9. Most hammer drills will not hammer until
Answer: Pressure is applied to the drill bit
10. A pneumatic drill is commonly used when
Answer: There is no electricity
11. Never use a circular saw that does not have a blade guard because
Answer: The guard protects you from touching the blade.
12. When using a circular saw be sure to
Answer: Cut on the waist side of the cut mark to allow for the blades kerf.
13. Saws with fine blades that are excellent for delicate and intricate cutting are
called
Answer: Saber saws
Questions and Verified Answers
100% Guarantee Pass
1. A saw that has a thin one-piece blade that runs around guides, that runs
around either end of the saw is a
Answer: Band saw
2. A power miter saw combines a miter box with a
Answer: Circular saw
3. An angle grinder is used to grind
Answer: Hard heavy materials
4. The adjustable tool rest on a bench grinder should be positioned
Answer: One eighth of an inch from the grinding tool
5. A good way to check the condition of the grinding wheel on a bench grinder is
to
Answer: Perform a ring test
6. A grinder can catch on rough material edges and shift around, especially
, when using rotary bits called
Answer: Burr bits
7. When using power tools never engage the
Answer: Trigger locks
8. Before replacing parts such as bits, blades, or discs on any tool, you must
Answer: -
Disconnect the power source
9. Most hammer drills will not hammer until
Answer: Pressure is applied to the drill bit
10. A pneumatic drill is commonly used when
Answer: There is no electricity
11. Never use a circular saw that does not have a blade guard because
Answer: The guard protects you from touching the blade.
12. When using a circular saw be sure to
Answer: Cut on the waist side of the cut mark to allow for the blades kerf.
13. Saws with fine blades that are excellent for delicate and intricate cutting are
called
Answer: Saber saws
