2026 ICC Res Elec Inspector- E1 Exam with all Correct &
100% Verified Answers |Latest Version |Already Graded
1. where an attic space is not provided with permeant 6 ft NEC 334.23&
320.23
stairs or a ladder, protection for feeder cables running (A)
across the face of the rafters in the attic
shall only be required within of the nearest
edge of the attic entrance.
2. Termination provisions of equipment for # 1 AWG NEC 110.14
circuits marked for conductors shall be (C)(1)(b)
used for conductors rated at a minimum of 75
degrees Celsius
3. what size EGC for 70 AMP circuit # 8 AWG NEC 250.122
4. A Feeder will be protected by fuses rated by counter top
125 Amp. What size AL EGC is required to be cooking
run in a raceway with feeder supply units, and
conductors? electric
dryer?
5. What load shall be provided for each20 Amp
circuit serving receptacles in a laundry area?
6. Given: Three appliances fastened in place are
as fol-lows: Dishwasher rated at 1800VA,
water heater at 6000 VA and room C at
1600VA. what is the mini-mum-calculated
demand load for all appliances?
7. What is the maximum percent of unbalance
load to be considered for a feeder neutral
load regarding
the ungrounded feeder conductors in the
supply elec-tric ranges, wall mounted ovens,
1/
16
, 2026 ICC Res Elec Inspector- E1 Exam with all Correct &
100% Verified Answers |Latest Version |Already Graded
#4 AWG NEC 250.122 NEC 220.53 =
1.8kVA+6kVa+1.6kVa=9.
4Kva X 100% =9400
VAD
1500VA NEC 220.51(A)
70% NEC 220.61(B)(1)
8. 80 % NEC 210.23(A)
(1)
2/
16
, 2026 ICC Res Elec Inspector- E1 Exam with all Correct &
100% Verified Answers |Latest Version |Already Graded
A+
What is the maximum rating of any one cord and
plug connected utilization equipment when not
fastened in place and supplied by 15 amp
branch circuit?
Individual NEC 625.40
9. Outlets installed for the purpose of charging
EV shall be supplied by branch circuit.
10. Ranges shall b supplied by a minimum branch circuit of 40AMP NEC
210.19(A)(3)
when the rating of ranges is 8.75kva or more.
11. What is the minimum amount of branch circuits re- 1-20AMP branch
circuit
quired to serve receptacles outlets located in the laun- NEC 210.11
(C)(2)
dry area of a dwelling ?
12. What is the minimum amount of branch circuits re- TWO 20 AMP
branch cir-
quired to serve receptacle outlets for small appliances cuits
210.11(C)()
located on the counter tops within the
kitchen area of the dwelling?
13. Where an NM exposed cable passes through shall be
a floor, the cable is a permitted to be installed
protected by which one of the following not less
wiring methods? than
from the
14. NM cable running parallel with stud framing edge of
3/
16
100% Verified Answers |Latest Version |Already Graded
1. where an attic space is not provided with permeant 6 ft NEC 334.23&
320.23
stairs or a ladder, protection for feeder cables running (A)
across the face of the rafters in the attic
shall only be required within of the nearest
edge of the attic entrance.
2. Termination provisions of equipment for # 1 AWG NEC 110.14
circuits marked for conductors shall be (C)(1)(b)
used for conductors rated at a minimum of 75
degrees Celsius
3. what size EGC for 70 AMP circuit # 8 AWG NEC 250.122
4. A Feeder will be protected by fuses rated by counter top
125 Amp. What size AL EGC is required to be cooking
run in a raceway with feeder supply units, and
conductors? electric
dryer?
5. What load shall be provided for each20 Amp
circuit serving receptacles in a laundry area?
6. Given: Three appliances fastened in place are
as fol-lows: Dishwasher rated at 1800VA,
water heater at 6000 VA and room C at
1600VA. what is the mini-mum-calculated
demand load for all appliances?
7. What is the maximum percent of unbalance
load to be considered for a feeder neutral
load regarding
the ungrounded feeder conductors in the
supply elec-tric ranges, wall mounted ovens,
1/
16
, 2026 ICC Res Elec Inspector- E1 Exam with all Correct &
100% Verified Answers |Latest Version |Already Graded
#4 AWG NEC 250.122 NEC 220.53 =
1.8kVA+6kVa+1.6kVa=9.
4Kva X 100% =9400
VAD
1500VA NEC 220.51(A)
70% NEC 220.61(B)(1)
8. 80 % NEC 210.23(A)
(1)
2/
16
, 2026 ICC Res Elec Inspector- E1 Exam with all Correct &
100% Verified Answers |Latest Version |Already Graded
A+
What is the maximum rating of any one cord and
plug connected utilization equipment when not
fastened in place and supplied by 15 amp
branch circuit?
Individual NEC 625.40
9. Outlets installed for the purpose of charging
EV shall be supplied by branch circuit.
10. Ranges shall b supplied by a minimum branch circuit of 40AMP NEC
210.19(A)(3)
when the rating of ranges is 8.75kva or more.
11. What is the minimum amount of branch circuits re- 1-20AMP branch
circuit
quired to serve receptacles outlets located in the laun- NEC 210.11
(C)(2)
dry area of a dwelling ?
12. What is the minimum amount of branch circuits re- TWO 20 AMP
branch cir-
quired to serve receptacle outlets for small appliances cuits
210.11(C)()
located on the counter tops within the
kitchen area of the dwelling?
13. Where an NM exposed cable passes through shall be
a floor, the cable is a permitted to be installed
protected by which one of the following not less
wiring methods? than
from the
14. NM cable running parallel with stud framing edge of
3/
16
