NEW MEXICO EE-98 ELECTRICAL CONTRACTOR NEWEST 2026
UPDATE ACTUAL EXAM SYLE PRACTICE QUESTIONS & CORRECT
ANSWERS | ALREADY GRADED A+
High-Probability Pass Sheet – Exam Type Practice
Most Tested Areas Covered:
• National Electrical Code (NEC) General Requirements
• Services, Feeders & Load Calculations
• Grounding & Bonding
• Overcurrent Protection
• Wiring Methods & Conductor Sizing
• Motors & Motor Controls
• Transformers
• Special Occupancies
• Boxes, Conduit & Fill Calculations
• New Mexico Laws & Contractor Responsibilities
• OSHA & Jobsite Safety
1. The NEC is primarily intended to:
A. Guarantee safe electrical installations
B. Provide minimum safety standards for electrical installations
C. Eliminate all electrical hazards
D. Serve as a design manual
,Answer: B
Explanation: The NEC provides minimum requirements for safe electrical
installations; it does not guarantee safety or replace sound engineering judgment.
2. For general lighting load calculations in dwelling units, the minimum load per
square foot is:
A. 2 VA
B. 3 VA
C. 180 VA
D. 220 VA
Answer: B
Explanation: NEC Article 220 requires 3 VA per square foot for general lighting load
in dwelling units.
3. The minimum cover depth for PVC conduit under a residential driveway is:
A. 12 inches
B. 18 inches
C. 24 inches
D. 6 inches
Answer: C
Explanation: NEC Table 300.5 requires 24 inches of cover for nonmetallic conduit
under driveways.
4. A 20-amp branch circuit must use a minimum conductor size of:
A. 14 AWG
B. 12 AWG
C. 10 AWG
D. 8 AWG
,Answer: B
Explanation: NEC 240.4(D) requires 12 AWG copper for 20-amp overcurrent
protection.
5. GFCI protection is required for receptacles in:
A. Living rooms
B. Bedrooms
C. Bathrooms
D. Closets
Answer: C
Explanation: NEC 210.8 requires GFCI protection in bathrooms.
6. The grounded conductor is typically:
A. Green
B. White or gray
C. Bare copper
D. Red
Answer: B
Explanation: NEC 200.6 identifies grounded conductors as white or gray.
7. Equipment grounding conductors are sized based on:
A. Conductor length
B. Service size
C. Overcurrent device rating
D. Voltage drop
Answer: C
Explanation: NEC 250.122 sizes equipment grounding conductors based on OCPD
rating.
, 8. The minimum number of small appliance circuits in a dwelling kitchen is:
A. One
B. Two
C. Three
D. Four
Answer: B
Explanation: NEC 210.11(C)(1) requires at least two small appliance branch
circuits.
9. Conductor ampacity is primarily affected by:
A. Color
B. Temperature rating
C. Manufacturer
D. Voltage rating
Answer: B
Explanation: Ampacity adjustments depend on temperature rating and ambient
correction factors.
10. EMT conduit fill is limited to what maximum percentage when containing
more than two conductors?
A. 31%
B. 40%
C. 53%
D. 60%
Answer: B
Explanation: NEC Chapter 9 limits conduit fill to 40% for more than two
conductors.
UPDATE ACTUAL EXAM SYLE PRACTICE QUESTIONS & CORRECT
ANSWERS | ALREADY GRADED A+
High-Probability Pass Sheet – Exam Type Practice
Most Tested Areas Covered:
• National Electrical Code (NEC) General Requirements
• Services, Feeders & Load Calculations
• Grounding & Bonding
• Overcurrent Protection
• Wiring Methods & Conductor Sizing
• Motors & Motor Controls
• Transformers
• Special Occupancies
• Boxes, Conduit & Fill Calculations
• New Mexico Laws & Contractor Responsibilities
• OSHA & Jobsite Safety
1. The NEC is primarily intended to:
A. Guarantee safe electrical installations
B. Provide minimum safety standards for electrical installations
C. Eliminate all electrical hazards
D. Serve as a design manual
,Answer: B
Explanation: The NEC provides minimum requirements for safe electrical
installations; it does not guarantee safety or replace sound engineering judgment.
2. For general lighting load calculations in dwelling units, the minimum load per
square foot is:
A. 2 VA
B. 3 VA
C. 180 VA
D. 220 VA
Answer: B
Explanation: NEC Article 220 requires 3 VA per square foot for general lighting load
in dwelling units.
3. The minimum cover depth for PVC conduit under a residential driveway is:
A. 12 inches
B. 18 inches
C. 24 inches
D. 6 inches
Answer: C
Explanation: NEC Table 300.5 requires 24 inches of cover for nonmetallic conduit
under driveways.
4. A 20-amp branch circuit must use a minimum conductor size of:
A. 14 AWG
B. 12 AWG
C. 10 AWG
D. 8 AWG
,Answer: B
Explanation: NEC 240.4(D) requires 12 AWG copper for 20-amp overcurrent
protection.
5. GFCI protection is required for receptacles in:
A. Living rooms
B. Bedrooms
C. Bathrooms
D. Closets
Answer: C
Explanation: NEC 210.8 requires GFCI protection in bathrooms.
6. The grounded conductor is typically:
A. Green
B. White or gray
C. Bare copper
D. Red
Answer: B
Explanation: NEC 200.6 identifies grounded conductors as white or gray.
7. Equipment grounding conductors are sized based on:
A. Conductor length
B. Service size
C. Overcurrent device rating
D. Voltage drop
Answer: C
Explanation: NEC 250.122 sizes equipment grounding conductors based on OCPD
rating.
, 8. The minimum number of small appliance circuits in a dwelling kitchen is:
A. One
B. Two
C. Three
D. Four
Answer: B
Explanation: NEC 210.11(C)(1) requires at least two small appliance branch
circuits.
9. Conductor ampacity is primarily affected by:
A. Color
B. Temperature rating
C. Manufacturer
D. Voltage rating
Answer: B
Explanation: Ampacity adjustments depend on temperature rating and ambient
correction factors.
10. EMT conduit fill is limited to what maximum percentage when containing
more than two conductors?
A. 31%
B. 40%
C. 53%
D. 60%
Answer: B
Explanation: NEC Chapter 9 limits conduit fill to 40% for more than two
conductors.
