Millwright Alberta Period 1 Final Alberta Apprenticeship and Industry
Exam Training
Millwright (Industrial Mechanic) - Period 1
Final Exam
Exam covarage
Trade Safety Practices (PPE, hazard
assessment, OH&S regulations)
Hand and Power Tool Identification and Use
Precision Measuring Instruments
(micrometers, calipers, dial indicators)
Basic Blueprint Reading and Trade Drawings
Fasteners and Thread Identification
Basic Rigging and Hoisting Principles
Lubrication Fundamentals and Types
Bearings (types, identification, installation
basics)
, Seals and Gaskets
Shaft Alignment Basics
Couplings and Keys
Basic Mechanical Drives (belts, chains,
gears - introduction)
Hydraulic and Pneumatic Fundamentals
Introduction to Welding and Cutting Safety
Shop Mathematics (metric/imperial
conversions, fractions, basic calculations)
Basic Metallurgy Concepts
Preventative Maintenance Procedures
Workplace Communication and
Documentation
when is a whimis label not when a controlled product is used
required? immediately
,intentional difference between allowance
mating parts?
the amount of variation tolerance
between parts
gap or space between mating clearance
parts
what is used with an outside a steel rule
caliper to measure a shaft?
vernier caliper smallest one thou if an inch 0.001" or 0.20mm
measurement?
, parallel misalignment + angular combination misalignment
misalignment
how to measure a small hole? small hole gauge and outside micrometer
Reading a Vernier bevel main scale is degrees and vernier scale is
protractor in what ? minutes indicates every 5 minutes = 1/12 of a
degree
What has to be aligned during Centerlines
machine installation
what's a datum line standard of comparison or point of
reference
Exam Training
Millwright (Industrial Mechanic) - Period 1
Final Exam
Exam covarage
Trade Safety Practices (PPE, hazard
assessment, OH&S regulations)
Hand and Power Tool Identification and Use
Precision Measuring Instruments
(micrometers, calipers, dial indicators)
Basic Blueprint Reading and Trade Drawings
Fasteners and Thread Identification
Basic Rigging and Hoisting Principles
Lubrication Fundamentals and Types
Bearings (types, identification, installation
basics)
, Seals and Gaskets
Shaft Alignment Basics
Couplings and Keys
Basic Mechanical Drives (belts, chains,
gears - introduction)
Hydraulic and Pneumatic Fundamentals
Introduction to Welding and Cutting Safety
Shop Mathematics (metric/imperial
conversions, fractions, basic calculations)
Basic Metallurgy Concepts
Preventative Maintenance Procedures
Workplace Communication and
Documentation
when is a whimis label not when a controlled product is used
required? immediately
,intentional difference between allowance
mating parts?
the amount of variation tolerance
between parts
gap or space between mating clearance
parts
what is used with an outside a steel rule
caliper to measure a shaft?
vernier caliper smallest one thou if an inch 0.001" or 0.20mm
measurement?
, parallel misalignment + angular combination misalignment
misalignment
how to measure a small hole? small hole gauge and outside micrometer
Reading a Vernier bevel main scale is degrees and vernier scale is
protractor in what ? minutes indicates every 5 minutes = 1/12 of a
degree
What has to be aligned during Centerlines
machine installation
what's a datum line standard of comparison or point of
reference
