NYC MASTER ELECTRICIAN EXAM Newest Exam
Preparation Newest With Complete Questions And Correct
Detailed Answers| Brand New Version
Where a main bonding jumper or a system bonding jumper is a screw only the
screw shall be identified with a ____ that shall be visible with the screw installed -
ans -Green finish
Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish them
from fuses of higher ampere rating - ans -Hexagon
The load for household electric clothes dryer's in a dwelling unit(s) shall be either
____ watts (volt-amperes) or the nameplate rating, which ever is larger, for each
dryer served ? - ans -5000 watts
Service conductors installed as unjacketed multiconductor cable shall have a
minimum clearance of ____ windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations. - ans -3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be permitted to be used only for
replacement in existing installation is where there is no evidence of over-fusing or
tampering. - ans -Class H
Branch circuit conductors within ____inches of the ballast shall have an insulation
temperature rating not lower it 90°C 194°F - ans -3" inches
The minimum radius of a field bend on trade size 1 "1/4 RMC is ____. - ans -8
In a dwelling unit which appliance is allowed to have a 24"inch cord with
Attachment ground plug ? - ans -Combination range hood/microwave oven
Type 3 Surge Protective devices can be installed on the load side of a branch
circuit overcurrent device up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a distance from the service or
separately derived system disconnect - ans -Included in the manufactures
instructions
,Which flexible cable is Allowed to be used for electric vehicle charging station 300
Volts ? - ans -EVJ
Type ____ fuse adapters shall be designed so that once inserted in a fuse holder
that cannot be removed - ans -Type S fuse
Service drops Installed over roof shall have a vertical clearance of ____ above the
roof surface, and unless a lesser distance is permitted by and exceptions - ans -8'ft
Class 2 and Class 3 circuits shall not be placed in any enclosure, raceway, cable, or
similar fittings with conductors of Class 1 or electric light or power conductors,
unless ____. - ans -Separated by barrier
In the critical care areas of health care centers, each patient bed shall be provided
with a minimum of ____ duplex receptacles - ans -3 duplex (6 single)
The equipment system shall supply major electric ____ necessary for patient care
and basic hospital operation - ans -Equipment
The essential electrical system in a healthcare facility shall be compromised of the
- ans -emergency system and the: equipment system
Locations were flammable anesthetics are employed are class I,Division I locations
that shall extend - ans -upwards to a level 5'ft above the floor
In a healthcare facility receptacles and attachment plugs in a hazardous
(classified) location with an anesthizing area shall be listed for use in class I group
____ locations - ans -Group C
In anesthetic,areas health care equipment frequently in contact with bodies of
persons shall not exceed ____ volts. - ans -10 Volts
In anesthetic areas, low-voltage equipment that is frequently in contact with the
bodies of persons or has exposed current-carrying elements shall - ans -operate
on an electrical potential of 10 volts or less,be moistur- resistant, be approved as
intrinsically safe or double-insulated equipment.
, In a healthcare facility, the maximum internal current permitted to flow through a
line isolated monitor,when any point of the isolated system is grounded, shall be
____ . - ans -1 milliamperes
Type ____ is multiconductor cable identified for use as underground service
entrance cable. - ans -Type USE cable
Knife switch rated for more than 1200 Amps at 250Volts or less - ans -Can be used
only as isolating switch, shall not be opened under load
Track lighting with outlets in a bathroom is not allowed because ? - ans -Track
lighting has receptacle
Where internal combustion engines are used as the prime motor, an on site fuel
supply shall be provided with an on premise fuel supply sufficient for not less than
____ hours full demand operation of the system - ans -6 hours
Fixed in place X-ray equipment properly supplied by a branch circuit rated at not
over ____ amperes shall be permitted to be supplied through a suitable
attachment plug cap and hard service cable cord. - ans -30 Amps
Where skin effect exist the ferromagnetic envelope shall be bonded at ____. - ans
-Both ends
GFCI protection at a carnival is not required for equipment at circuit if the
receptacle is of the ____type. - ans -Locking
The maximum voltage drop from service point to the last over-current device in a
dwelling unit? - ans -4%
Which of the following statements best describe the grounding requirement for
central vacuum outlet - ans -Accessible non current carrying metal parts are
required to be connected to an equipment grounding conductor.
In healthcare facilities, patient bed receptacles located in general care areas shall
be supplied by at least two branch circuits, which ____permitted to originate
Preparation Newest With Complete Questions And Correct
Detailed Answers| Brand New Version
Where a main bonding jumper or a system bonding jumper is a screw only the
screw shall be identified with a ____ that shall be visible with the screw installed -
ans -Green finish
Plug fuses a 15 amperes and lower rating shall be identified by a ____
configuration of the window, cap, or other prominent part to distinguish them
from fuses of higher ampere rating - ans -Hexagon
The load for household electric clothes dryer's in a dwelling unit(s) shall be either
____ watts (volt-amperes) or the nameplate rating, which ever is larger, for each
dryer served ? - ans -5000 watts
Service conductors installed as unjacketed multiconductor cable shall have a
minimum clearance of ____ windows that are designed to be opened, doors,
porches, stairs fire escape or similar locations. - ans -3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be permitted to be used only for
replacement in existing installation is where there is no evidence of over-fusing or
tampering. - ans -Class H
Branch circuit conductors within ____inches of the ballast shall have an insulation
temperature rating not lower it 90°C 194°F - ans -3" inches
The minimum radius of a field bend on trade size 1 "1/4 RMC is ____. - ans -8
In a dwelling unit which appliance is allowed to have a 24"inch cord with
Attachment ground plug ? - ans -Combination range hood/microwave oven
Type 3 Surge Protective devices can be installed on the load side of a branch
circuit overcurrent device up to the equipment served.if ____ the type 3 SPD
connection must be a minimum 30'ft of conductor a distance from the service or
separately derived system disconnect - ans -Included in the manufactures
instructions
,Which flexible cable is Allowed to be used for electric vehicle charging station 300
Volts ? - ans -EVJ
Type ____ fuse adapters shall be designed so that once inserted in a fuse holder
that cannot be removed - ans -Type S fuse
Service drops Installed over roof shall have a vertical clearance of ____ above the
roof surface, and unless a lesser distance is permitted by and exceptions - ans -8'ft
Class 2 and Class 3 circuits shall not be placed in any enclosure, raceway, cable, or
similar fittings with conductors of Class 1 or electric light or power conductors,
unless ____. - ans -Separated by barrier
In the critical care areas of health care centers, each patient bed shall be provided
with a minimum of ____ duplex receptacles - ans -3 duplex (6 single)
The equipment system shall supply major electric ____ necessary for patient care
and basic hospital operation - ans -Equipment
The essential electrical system in a healthcare facility shall be compromised of the
- ans -emergency system and the: equipment system
Locations were flammable anesthetics are employed are class I,Division I locations
that shall extend - ans -upwards to a level 5'ft above the floor
In a healthcare facility receptacles and attachment plugs in a hazardous
(classified) location with an anesthizing area shall be listed for use in class I group
____ locations - ans -Group C
In anesthetic,areas health care equipment frequently in contact with bodies of
persons shall not exceed ____ volts. - ans -10 Volts
In anesthetic areas, low-voltage equipment that is frequently in contact with the
bodies of persons or has exposed current-carrying elements shall - ans -operate
on an electrical potential of 10 volts or less,be moistur- resistant, be approved as
intrinsically safe or double-insulated equipment.
, In a healthcare facility, the maximum internal current permitted to flow through a
line isolated monitor,when any point of the isolated system is grounded, shall be
____ . - ans -1 milliamperes
Type ____ is multiconductor cable identified for use as underground service
entrance cable. - ans -Type USE cable
Knife switch rated for more than 1200 Amps at 250Volts or less - ans -Can be used
only as isolating switch, shall not be opened under load
Track lighting with outlets in a bathroom is not allowed because ? - ans -Track
lighting has receptacle
Where internal combustion engines are used as the prime motor, an on site fuel
supply shall be provided with an on premise fuel supply sufficient for not less than
____ hours full demand operation of the system - ans -6 hours
Fixed in place X-ray equipment properly supplied by a branch circuit rated at not
over ____ amperes shall be permitted to be supplied through a suitable
attachment plug cap and hard service cable cord. - ans -30 Amps
Where skin effect exist the ferromagnetic envelope shall be bonded at ____. - ans
-Both ends
GFCI protection at a carnival is not required for equipment at circuit if the
receptacle is of the ____type. - ans -Locking
The maximum voltage drop from service point to the last over-current device in a
dwelling unit? - ans -4%
Which of the following statements best describe the grounding requirement for
central vacuum outlet - ans -Accessible non current carrying metal parts are
required to be connected to an equipment grounding conductor.
In healthcare facilities, patient bed receptacles located in general care areas shall
be supplied by at least two branch circuits, which ____permitted to originate
