MASSACHUSETTS MASTER PIPEFITTER STUDY SET
(FEBRUARY 2017) FINAL STUDY GUIDE QUESTIONS AND
CORRECT DETAILED ANSWERS WITH RATIONALES
(VERIFIED ANSWERS) |ALREADY GRADED A+
VERIFIED ANSWERS EXAM QUESTIONS
Jack Stands 1. Vertically adjustable support devices
used in the repair or fabrication of pipe
are called ________________ .
Strap 2. Polished or plated pipe is removed or
installed with a(n)
___________________ wrench to
prevent damage to the pipe.
Level 3. A pipe that is horizontally aligned is
referred to as being _______________.
Framing 4. Spirit level 18 to 48 inches long are
commonly referred to as
__________________ levels.
Combination TRI 5. Tables and graduations that eliminate
many calculations are available on the
, ________________ square.
hi-lo guage 6. Pipe joints misalignment is checked
with a _______________.
Drift Pin 7. To align bolt holes when connecting
flanges, use a _______________.
Two-hole pin 8. Which of the following is used to orient
a flange on the end of a pipe?
Forward 9. A hacksaw cuts on the
_________________ stroke.
Reamer 10. Internal burrs on pipe and tubing are
removed with a(n)
______________________.
Cannot be mixed 11. Die sets for hand pipe threaders
______________.
Sharp 12. Use care in handling freshly cut pipe
threads because they are
___________________.
One 13. When threading pipe using a manual
pipe threader, the thread cutting process
is complete when
_____________________ thread(s)
extend from the back of the last tooth.
Soil Pipe Cutter 14. Ductile Pipe cannot be cut with a(n)
(FEBRUARY 2017) FINAL STUDY GUIDE QUESTIONS AND
CORRECT DETAILED ANSWERS WITH RATIONALES
(VERIFIED ANSWERS) |ALREADY GRADED A+
VERIFIED ANSWERS EXAM QUESTIONS
Jack Stands 1. Vertically adjustable support devices
used in the repair or fabrication of pipe
are called ________________ .
Strap 2. Polished or plated pipe is removed or
installed with a(n)
___________________ wrench to
prevent damage to the pipe.
Level 3. A pipe that is horizontally aligned is
referred to as being _______________.
Framing 4. Spirit level 18 to 48 inches long are
commonly referred to as
__________________ levels.
Combination TRI 5. Tables and graduations that eliminate
many calculations are available on the
, ________________ square.
hi-lo guage 6. Pipe joints misalignment is checked
with a _______________.
Drift Pin 7. To align bolt holes when connecting
flanges, use a _______________.
Two-hole pin 8. Which of the following is used to orient
a flange on the end of a pipe?
Forward 9. A hacksaw cuts on the
_________________ stroke.
Reamer 10. Internal burrs on pipe and tubing are
removed with a(n)
______________________.
Cannot be mixed 11. Die sets for hand pipe threaders
______________.
Sharp 12. Use care in handling freshly cut pipe
threads because they are
___________________.
One 13. When threading pipe using a manual
pipe threader, the thread cutting process
is complete when
_____________________ thread(s)
extend from the back of the last tooth.
Soil Pipe Cutter 14. Ductile Pipe cannot be cut with a(n)
