NEIEP 100 EXAM READY - VERIFIED QUESTIONS AND
ANSWERS LATEST VERSION
ANSWER Multiply by 2.2 to convert kilograms to pounds
ANSWER : Divide by 2.2 to convert pounds to kilograms.
What kinds of detail drawings are typical for an elevator installation project?
ANSWER Electrical, structural, hoistway, and standardized drawings
Setting up limit switches for hoistways Which drawing is the mechanic going to
refer to? ANSWER standardized detail drawing
When installing them, where should a lifeline be placed? ANSWER : near
enough to allow tying off before entering
To convert millimeters to inches, divide the ANSWER by 25.4.
To convert inches to millimeters, multiply the ANSWER by 25.4.
What phrase is used to identify drawings that have been accepted by the
building owner or representative? ANSWER Final
Where should a back view be placed if necessary in a normal orthographic
projection drawing? ANSWER Off to one side of the working picture
Which drawing technique is most frequently used in the elevator industry to
display an object's three sides simultaneously? ANSWER Isometric Drawing
What is a class 3 fit for shaft and bore diameters? ANSWER : Provide a
potential allowance.
Which bolt class— ANSWER Class 3 bolts—offers the highest degree of
precision?
What distinguishes metric standard threads from U.S. standard threads?
ANSWER The metric standard measures by the pitch of the threads, while the
ANSWERS LATEST VERSION
ANSWER Multiply by 2.2 to convert kilograms to pounds
ANSWER : Divide by 2.2 to convert pounds to kilograms.
What kinds of detail drawings are typical for an elevator installation project?
ANSWER Electrical, structural, hoistway, and standardized drawings
Setting up limit switches for hoistways Which drawing is the mechanic going to
refer to? ANSWER standardized detail drawing
When installing them, where should a lifeline be placed? ANSWER : near
enough to allow tying off before entering
To convert millimeters to inches, divide the ANSWER by 25.4.
To convert inches to millimeters, multiply the ANSWER by 25.4.
What phrase is used to identify drawings that have been accepted by the
building owner or representative? ANSWER Final
Where should a back view be placed if necessary in a normal orthographic
projection drawing? ANSWER Off to one side of the working picture
Which drawing technique is most frequently used in the elevator industry to
display an object's three sides simultaneously? ANSWER Isometric Drawing
What is a class 3 fit for shaft and bore diameters? ANSWER : Provide a
potential allowance.
Which bolt class— ANSWER Class 3 bolts—offers the highest degree of
precision?
What distinguishes metric standard threads from U.S. standard threads?
ANSWER The metric standard measures by the pitch of the threads, while the
